Weider Pro 4100 English Manual - Page 9

11. Press the two Weight Guide Bushings (44) into the Center Top Frame (14). Slide the Center Top Frame onto the Weight Guides (20). Attach the Center Top Frame (14) to the Right Top Frame (8) with two 5/16" x 2 3/4" Bolts (60), two 5/16" Washers (26), and two 5/16" Nylon Locknuts (71). Attach the Center Top Frame (14) to the Left Top Frame (3) with two 5/16" x 2 3/4" Bolts (60), two 5/16" Washers (26), and two 5/16" Nylon Locknuts (71). Tighten all of the 5/16" Nylon Locknuts (71) used in steps 3-11. Note: The remaining hardware from the "Frame Assembly" bag will be used later. ARM ASSEMBLY 12. Press a 1 1/2" Square Inner Cap (41) into the Right Upright (6). Press a 2" x 2 1/2" Inner Cap (22) into the Butterfly Frame (9). Lubricate a 3/8" x 3" Bolt (61) with grease. Attach the Butterfly Frame (9) to the Right Top Frame (8) with the Bolt and a 3/8" Nylon Locknut (70). Do not overtighten the Locknut; the Butterfly Frame must be able to pivot easily. 11 71 44 71 14 60 26 71 8 71 26 60 26 20 3 12 8 22 41 70 Lubricate 6 61 13. Lubricate a 3/8" x 2" Bolt (62) with grease. Attach the Pivot Bracket (48) to the Right Butterfly Arm (11) with the Bolt and a 3/8" Nylon Jamnut (50). Do not overtighten the Locknut; the Pivot Bracket must be able to pivot easily. 13 Press a 1 1/2" x 2" Inner Cap (23) into the indicated end of the Right Butterfly Arm (11). Wet the bottom end of the Arm with soapy water. Slide a Large Foam Pad (19) onto the Arm. Slide a Foam Grip (76) onto a Press Handle (12). Press a 1" Round Inner Cap (24) into the end of the Handle. Attach the Handle to the Right Butterfly Arm (11) with two 5/16" x 3/4" Button Head Screws (64) and two Nut Clips (99). Slide the Large Foam Pad (19) down so that the bottom of the Foam Pad is even with the bottom of the Right Butterfly Arm (11). 64 19 99 Repeat this step with the Left Butterfly Arm (10). 9 9 Lubricate 62 48 64 11 23 50 24 10 76 12