Weider Pro 9510 English Manual - Page 14
Seat Assembly
View all Weider Pro 9510 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
SEAT ASSEMBLY 29. Press a 1 1/2" Square Inner Cap (32) into the 29 Seat Frame (36). Insert the 1/4" x 2" Carriage Bolt (38) into the center hole in the Seat Plate (37). Attach the Seat Plate to the Seat (13) with two 1/4" x 1/2" Screws (18). Insert the 1/4" x 2" Carriage Bolt (38) into the indicated hole in the Seat Frame (36). Tighten a 1/4" Nylon Locknut (2) with a 1/4" Flat Washer (10) onto the Carriage Bolt. Attach the other end of the Seat (13) to the Seat Frame (36) with a 1/4" Flat Washer (10) and a 1/4" x 2" Screw (24). 30 30. Lubricate the 5/16" x 2 1/4" Bolt (33). Attach the Leg Lever (29) to the Seat Frame (36) with the 5/16" x 2 1/4" Bolt and a 5/16" Nylon Locknut (3). 13 38 37 18 36 32 24 10 2 36 33 3 Lubricate 29 31. Attach the Short Cable (35) to one of the 31 three holes in the Leg Lever (29) with a 5/16" x 3/4" Bolt (89), a 5/16" Washer (8), and a 5/16" Nylon Locknut (3). Note: The three holes are for cable adjustment. Insert the Short Cable between the welded rod and the Leg Lever. Press a 1" Round Inner Cap (49) into each end of the Curl Bar (86). Slide the 5/8" x 3/8" Bushing (91), the Curl Bar, and the Short Cable (35) onto the 5/16" x 1 1/4" Carriage Bolt (90). Hand tighten a 5/16" Nylon Locknut (3) onto the Carriage Bolt. 32. Rest the Seat Frame (36) on the indicated pin in the Front Upright (42). Attach the Seat 32 Frame to the Front Upright with a 5/16" x 2 3/4" Carriage Bolt (14) and the Seat Knob (40). 29 89 8 3 Welded Rod 3 35 49 86 40 36 14 49 91 90 Pin 42 14