Weider Pro 9510 English Manual - Page 15

SEAT ASSEMBLY 33. Press 3/4" Round Inner Caps (34) into the ends of both 12 1/2" Pad Tubes (28). Insert one 12 1/2" Pad Tube (28) into the Seat Frame (36). Slide a 5 1/2" Pad (30) onto each end of the Pad Tube. Insert the other 12 1/2" Pad Tube (28) into the Leg Lever (29). Slide a 5 1/2" Pad (30) onto each end of the Pad Tube. See the left inset drawing. Insert the head of the 5/16" x 1 1/4" Carriage Bolt (90) into the keyhole in the Leg Lever (29). Be sure that the shoulder of the Carriage Bolt is firmly seated in the square part of the keyhole. See the right inset drawing. Orient the Short Cable (35) and the Curl Bar (86) as shown. Tighten the indicated 5/16" Nylon Locknut (3). Do not overtighten the Nylon Locknut. This is the storage position for the Curl Bar. 33 36 30 29 29 Keyhole 90 34. Attach the Curl Pad (82) to the Curl Frame (84) with four 1/4" x 1/2" Screws (18). Insert a 1 1/2" Square Inner Cap (32) into each end of the Curl Frame (84). Note: These Square Inner Caps may come preassembled. 34 32 18 30 34 28 34 3 86 35 82 35. Attach the Curl Frame (84) to the Seat Frame (36) by inserting the pin on the Curl Frame into the upper hole in the Seat Frame. Secure the Curl Frame with the Curl Knob (85). 18 32 35 18 84 85 84 36 15