Weider Pro 9510 English Manual - Page 8
Arm Assembly
View all Weider Pro 9510 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
ARM ASSEMBLY 8. Wet the handle of one Press Arm (46) with 8 soapy water. Slide a Hand Grip (31) onto the handle. Press a 1" Round Inner Cap (49) into the other end of the handle. Press a 1 3/4" Square Inner Cap (44) into the Press Arm. 44 Attach the Press Arm (46) to one side of the 49 Press Frame (17) with two 5/16" x 2 1/2" Bolts (22) and two 5/16" Nylon Locknuts (3). 44 49 31 46 22 Assemble the other Press Arm (46) in the same manner. 46 3 17 9. Identify the Right Arm (48) and the Left Arm 9 (47). Note the position of the welded 7 50 bracket on each Arm. Arm identification is very important for step 10. Attach a "V"-Pulley (6) and a Long Cable Trap (50) to the Right Arm (48) with a 3/8" x 2 1/2" Bolt (7) and a 3/8" Nylon Locknut (21). 50 6 Welded Brackets 6 47 21 48 Attach a "V"-Pulley (6) and a Long Cable Trap (50) to the Left Arm (47) in the same manner. 10. Lubricate both axles on the Top Frame (55). Slide the Right Arm (48) onto the right axle. Note: Be careful not to confuse the Right Arm with the Left Arm (47); refer to step 9 to identify the Right Arm. Be sure that the upper end of the Right Arm is behind the indicated bracket on the Top Frame (55). Tap two 1" Retainers (69) and a 1" Round Cover Cap (70) onto the right axle. Be sure that the teeth on the Retainers bend toward the Cover Cap, as shown in the inset drawing. Attach the Left Arm (47) in the same manner. Press 1 3/4" Square Inner Caps (44) into the lower ends of the Right and Left Arms (47, 48). Wet the lower end of each Arm with soapy water. Slide a 10" Pad (45) onto the lower end of each Arm. 10 48 44 45 55 47 Bracket Lubricate Axle 69 70 45 55 69 70 8