Weider Pro 9735 English Manual - Page 23
Cable Assembly, Seat Assembly
View all Weider Pro 9735 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
CABLE ASSEMBLY 56. Wrap the Press Cable (88) around a "V" 56 Pulley (81). Attach the "V" Pulley and a Large Cable Trap (83) to the bracket on the Front Seat Frame (8) with a 3/8" x 2 1/2" Bolt (65) and a 3/8" Nylon Locknut (42). Be sure that the Large Cable Trap is turned to hold the Cable in place and that the Cable and Pulley move smoothly. 83 65 81 57. Note: The 3 1/2" Pulley (82) used in this step was attached in step 55. It is shown 57 removed for easier part identification. Route the Press Cable (88) around the 3 1/2" Pulley (82). Be sure that the Cable Trap (80) is turned to hold the Cable in place and that the Cable is routed as shown. Tighten the 3/8" x 4 1/2" Bolt (74) and the 3/8" Nylon Jam Nut (43). 88 42 74 8 9 43 82 80 88 58. Slide a 5/16" Washer (20) onto a 5/16" x 2 3/4" 58 Bolt (55). Insert the Bolt into the Front Seat Frame (8). Fully tighten a 5/16" Nylon Jam Nut (91) onto the Bolt. Slide the end of the Press Cable (88) onto the Bolt. Thread anoth- er 5/16" Nylon Jam Nut (91) onto the Bolt, but do not fully tighten it. Leave enough room between the two Jam Nuts for the Cable to pivot. 59. Locate and open the parts bag labeled "SEAT ASSEMBLY." Attach the Large Backrest (19) to the Leg Press Upright (4) with two 1/4" x 2 1/2" Machine Screws (64) and two 1/4" Washers (37). 55 59 88 8 91 20 4 64 19 37 SEAT ASSEMBLY 23