Weider Pro 9940 English Manual - Page 11

18. Press a 1 3/4" Square Inner Cap (35) into each end of the Right Butterfly Arm (11). Wet the lower end of the Arm with soapy water. Slide a Butterfly Foam Pad (29) onto the lower end of the Arm. Lubricate the indicated axle on the Butterfly Top Frame (33). Orient the Right Butterfly Arm (11) as shown and slide it onto the axle. Secure the Butterfly Arm with two Retainer Rings (31) and a 1" Round Outer Cap (38). Note: Place the Retainer Rings on top of the inverted Outer Cap and gently tap the Cap onto the axle with a hammer. Make sure the teeth on the Retainer Rings bend towards the Cap as shown in the inset drawing. Repeat this step to assemble the Left Butterfly Arm (10, not shown). 18 11 35 33 Axle 35 31 38 29 Cable Assembly 19. Locate and open the parts bag labeled "CABLE 19 ASSEMBLY." For Cable identification and routing during steps 19 to 49, refer to the Cable Diagrams and Cable ID Chart on pages 23 and 24. Identify the Butterfly Cable (73). It is approximately 52" long and it has a closed loop on each end. Attach the Butterfly Cable to the bracket on the Left Butterfly Arm (10) with a 3/8" x 1" Bolt (84) and two 3/8" Nylon Jamnuts (63). Note: The loop on the Cable and the two Nylon Jamnuts must be mounted underneath the welded bracket. 20. Locate and open the parts bag labeled "PULLEY 20 BAG 2." Remove one "V"-Pulley (27) from the bag. Leave the remaining pulleys in the bag for identification of the Pro Pulley. Wrap the Butterfly Cable (73) around a "V"-Pulley (27) in the direction shown. Attach the "V"-Pulley and a Large Cable Trap (32) to the bracket on the back of the Butterfly Upright (1) with a 3/8" x 2 1/2" Bolt (53) and a 3/8" Nylon Locknut (50). Make sure the Large Cable Trap is oriented as shown. 11 Axle 31 Teeth 38 84 Bracket 63 10 73 32 27 53 50 Bracket 73 1