Weider Pro 9940 English Manual - Page 8

9. Press a 2" Square Inner Cap (28) into the Press Seat 9 Frame (7). Slide the bracket on the Press Seat Frame (7) onto the indicated 5/16" x 2 1/2" Carriage Bolts (92) in the Press Base (6). Hand tighten two 5/16" Nylon 28 Locknuts (64) onto the Bolts. Do not tighten the Nylon Locknuts yet. 64 Attach the Press Seat Frame (7) to the Press Upright (2) with two 5/16" x 2 3/4" Bolts (89), two 5/16" Washers (36), and two 5/16" Nylon Locknuts (64). Do not tighten the Nylon Locknuts yet. 10. Lubricate the 3/8" x 3" Bolt (88). Attach the Leg Press 10 Lever (83) to the Press Base (6) with the Bolt and a 3/8" Nylon Locknut (50). Do not overtighten the Nylon Locknut; the Leg Press Lever must pivot easily. 89 36 7 64 36 89 64 2 6 92 83 50 11. Place two Weight Bumpers (51) over the indicated holes in the Weight Base (5). Slide a Weight Guide (15) into each of the holes. Attach the indicated Weight Guide (15) to the Weight Base (5) with a 3/8" x 2 3/4" Bolt (46), two 3/8" Flat Washers (48), and a 3/8" Nylon Locknut (50). Slide six Weights (21) onto the Weight Guides (15). Make sure the Weights are turned so the pin grooves point towards the floor. Press a Weight Tube Bumper (18) into the lower end of the Short Weight Tube (17). Slide the Weight Tube into the center holes in the Weights (21). Slide a Top Weight (16) onto the Weight Guides (15). Note: Make sure the Top Weight is turned so the groove fits over the welded pin on the Weight Tube (17). 11 15 16 Groove Pin 17 21 Pin Grooves 5 48 46 8 6 Lubricate 88 18 51 48 50