Weider Pro 9940 English Manual - Page 18

43. Wrap the Press Cable (72) around a 3 1/2" Pulley 43 (24) in the direction shown. Attach the Pulley and a Cable Trap (25) to the indicated hole on the far side 72 of the Leg Press Lever (83) with a 3/8" x 4 3/4" Bolt (60) and a 3/8" Nylon Jamnut (63). Note: Thread the 60 Jamnut only two turns onto the Bolt; you will later attach another Pulley to the Bolt. Make sure the 24 Cable Trap is oriented as shown. 25 83 63 44. Wrap the Press Cable (72) around a "V"-Pulley (27) 44 in the direction shown. Attach the "V"-Pulley and a Large Cable Trap (32) underneath the Press Seat Frame (7) with a 3/8" x 4 1/4" Bolt (85), a 3/8" Flat Washer (48), and a 3/8" Nylon Locknut (50). Note: 48 the Press Seat Frame has five adjustment holes. Mount the "V"-Pulley in the hole closest to the Leg Press Lever. Make sure the Cable Trap is ori- 27 ented as shown. 7 85 32 72 45. Wrap the Press Cable (72) around a 3 1/2" Pulley (24) in the direction shown. Attach the Pulley and a Cable Trap (25) to the near side of the Leg Press Lever (83). Use the 3/8" x 4 3/4" Bolt (60) that was inserted in step 43 and secure the Pulley with the 3/8" Nylon Jamnut (63). Make sure the Cable Trap is oriented as shown. 45 83 60 25 50 24 8 72 63 46. Wrap the Press Cable (72) around a 3 1/2" Pulley 46 (24) in the direction shown. Attach the Pulley and a Cable Trap (25) to near side of the Press Upright (2). Use the 3/8" x 4 3/4" Bolt (60) that was inserted in step 42 and secure the Pulley with the 3/8" Nylon 2 Jamnut (63). Make sure the Cable Trap is oriented as shown. Wrap the Press Cable (72) around a 3 1/2" Pulley (24) in the direction shown. Attach the Pulley and a Cable Trap (25) to the 3/8" x 4" Carriage Bolt (102) that was inserted into the Press Base (6) earlier. Secure the Pulley with the 3/8" Nylon Locknut (50). Make sure the Cable Trap is oriented as shown. 18 50 24 25 102 25 72 60 24 63