Weider Pro 9940 English Manual - Page 27

The threaded ends on the Press Cable (72) and the Ab Cable (74) that are attached to the weight stacks can also be used to tighten the cables. To tighten the Ab Cable (74), remove the "U"-Bracket (97) from the Short Weight Tube (17) by removing the 5/16" x 1 3/4" Bolt (96) and the 5/16" Nylon Locknut (64). Tighten the 1/4" Nylon Locknut (68) at the end of the Ab Cable (74) as far as it will go. Then re-attach the "U"Bracket (97). The Press Cable (72) can be tightened the same way. When you are tightening the cables, take note that they are linked into two distinct groups. The Butterfly Cable (73), the Ab Cable (74), and the Low Pulley Cable (75) are all connected to the small weight stack. All three cables will be tightened by tightening the Ab Cable (74) as described above or by using the Adjustable Pulley Plates (23) as described on the previous page. The Press Cable (72) is the only cable attached to the large weight stack. It must be tightened by using the method described above or by moving the "V"-Pulleys as described on the previous page. 74 64 97 72 96 71 68 17 Weight Resistance Chart The chart below shows the approximate weight resistance at each exercise station. "Top" refers to the 6 lb. top weight; the other numbers refer to the 12.5 lb. weight plates. Note: The actual resistance at each station may vary due to differences in individual weight plates as well as friction between the cables, pulleys, and weight guides. Weight Plates Top 1 2 3 4 5 6 7 8 9 10 High Pulley (lbs.) 14 28 42 56 69 83 97 111 124 138 152 Arm Press (lbs.) 16 37 58 79 100 121 142 163 184 205 226 Leg Press (lbs.) 21 48 75 101 128 155 181 208 235 262 288 Butterfly (lbs.) 8 23 38 52 67 82 97 Curl/ Ab Pulley/ Low Pulley Leg Raise (lbs.) (lbs.) 10 8 24 21 37 35 50 48 64 62 77 76 90 89 27