Weider Sy Pro 6900 Canadian English Manual - Page 14
Attach the Thick Pulley 48 and two Half Guards
View all Weider Sy Pro 6900 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
16. Identify the two V-pulleys (46), the nine Thick Pulleys (not shown), and the two Thin Pulleys 16 (not shown). Tip: It may be helpful to refer to the EXPLODED DRAWING near the end of this manual to identify the pulleys. Route the Arm Cable (54) over a V-pulley (46). Attach the V-pulley (46), a Large Cable Trap (50), two Full Guards (41), and an M10 Washer (57) to the Upright (3) with an M10 x 63mm Bolt (75) and an M10 Locknut (56). Make sure that the Large Cable Trap (50) is oriented to hold the Arm Cable (54) in the groove of the V-pulley (46). 17. Route the Arm Cable (54) around a Thick Pulley (48). 17 Attach the Thick Pulley (48) and two Half Guards (43) to the Double U-bracket (63) with an M10 x 46mm Bolt (81) and an M10 Locknut (56). Make sure that the Half Guards are on the outside of the Double U-bracket as shown. 3 41 57 46 50 41 75 56 54 54 43 81 48 56 43 63 18. Route the Arm Cable (54) over a V-pulley (46). 18 Attach the V-pulley (46), a Large Cable Trap (50), two Full Guards (41), and an M10 Washer (57) to the Upright (3) with an M10 x 63mm Bolt (75) and an M10 Locknut (56). Make sure that the Large Cable Trap (50) is oriented to hold the Arm Cable (54) in the groove of the V-pulley (46). 75 41 50 46 54 57 41 3 56 14