Weider Sy Pro 6900 Canadian English Manual - Page 21

36. Attach a Shroud Support (19) and the bottom of the Left Shroud (17) to the Base (1) and the 36 Stabilizer (2) with four M4.2 x 16mm Self-tapping Screws (49) and four M4 Washers (33). Do not tighten the Screws yet. Repeat steps 35 and 36 to attach the Right Shroud (not shown). See steps 35 and 36. Tighten the M4.2 x 16mm Self-tapping Screws (49) and the M4 x 12mm Screws (78). 37. Attach the Curl Pad (14) to the Curl Post (13) with two M6 x 16mm Screws (62). 37 17 2 1 33 49 33 19 49 14 62 13 38. Make sure that all parts have been properly tightened. The use of the remaining parts will be explained in ADJUSTMENT, beginning on page 22. Before using the weight system, pull each cable a few times to make sure that the cables move smoothly around the pulleys. If one of the cables does not move smoothly, find and correct the problem. IMPORTANT: If the cables are not properly installed, they may be damaged when heavy weight is used. See the CABLE DIAGRAM on page 26 for proper cable routing. If there is any slack in the cables, you will need to remove the slack by tightening the cables. See MAINTENANCE on page 25. 21