Weider Sy Pro 6900 Canadian English Manual - Page 17

25. Attach the Low Cable (53) to the U-bracket (45) with an M8 Washer (59) and an M8 Locknut (58). 25 See the inset drawing. Do not overtighten the M8 Locknut (58); it should be threaded onto the end of the Low Cable (53) so that only two threads are showing above the Locknut. 58 45 59 53 45 58 53 26. See the CABLE DIAGRAM. Identify the High Cable (55). 26 Route the High Cable (55) upward through the Top Frame (4) and over a Thick Pulley (48). Make sure that the eyelet end of the High Cable is in the indicated location. 48 56 57 52 Attach the Thick Pulley (48) inside the Top Frame (4) with an M10 x 67mm Bolt (71), two M10 Washers (57), two 13mm Spacers (52), and an M10 Locknut (56). 55 Eyelet 4 52 57 71 27. Route the High Cable (55) over a Thin Pulley (47) and downward through the Top Frame (4). 27 Attach the Thin Pulley (47) inside the Top Frame (4) with an M10 x 67mm Bolt (71), an M10 Washer (57), and an 11mm Spacer (86). Make sure that the Thin Pulley does not fall out of the Top Frame while you complete steps 28 and 29. Note: Another Thin Pulley (not shown) will be installed inside the Top Frame (4) with the same M10 x 67mm Bolt (71) in step 29. 55 47 4 86 57 71 17