Weider Viper 2000 Uk Manual - Page 12

26. Press a 1 1/2" Inner Cap (32) into the Seat Frame 26 (36). 13 Insert a 1/4" x 2" Carriage Bolt (38) into the centre of each Seat Plate (37). Attach the Seat Plates to the Seat (13) with four 1/4" x 3/4" Screws (18). Insert the two 1/4" x 2" Carriage Bolts (38) into the Seat Frame (36). Make sure that the Seat (13) is turned so the wide end is toward the 1 1/2" Inner Cap (32). Tighten a 1/4" Nylon Locknut (7) with 1/4" Flat Washer (10) onto each Carriage Bolt. 37 38 Wide End 18 37 32 10 36 7 27. Press a 1 1/2" Inner Cap (32) into the Leg Lever (29). 27 Attach the 5/16" x 2" Eyebolt (62) to the Leg Lever (29) with a 5/16" Flat Washer (8) and a 5/16" Nylon Locknut (3). Lubricate a 5/16" x 2 1/4" Bolt (33). Attach the Leg Lever (29) to the Seat Frame (36) with the Bolt and a 5/16" Nylon Locknut (3). Do not overtighten the Nylon Locknut; the Leg Lever must be able to pivot freely. 3 36 33-Lubricate 29 62 8 32 3 28. Set the bracket on the Seat Frame (36) onto the 28 indicated pins on the Front Upright (42). Attach the Seat Frame with a 5/16" x 2 3/4" Carriage Bolt (14) and the Seat Knob (40). Press 3/4" Round Inner Caps (34) into the ends of the 13 1/2" Pad Tube (28). Insert the Pad Tube into the Seat Frame (36). Slide a 6" Pad (30) onto each end of the Pad Tube. Press 3/4" Round Inner Caps (34) into the ends of the 13" Pad Tube (31). Insert the Pad Tube into the Leg Lever (29). Slide a 5 1/2" Pad (50) onto each end of the Pad Tube. 40 36 28 30 14 42 Pin 30 34 31 50 34 29 50 29. Press 1 1/2" Inner Caps (32) into the Left and 29 Right VKR Arms (100, 101). Attach the Left and Right VKR Arms (100, 101) to the Rear Upright (82) with two 5/16" x 2 3/4" Bolts (11) and 5/16" Nylon Locknuts (3). 101 11 3 82 100 32 12