Weider Viper 2000 Uk Manual - Page 8

12. Press two 1 3/4" Inner Caps (44) into each of the Arms (46). Apply lubricant to the lower axles on the Arm Frame (52). Slide an Arm (46) onto one of the axles. Hold two 1" Retainers (54) and a 1" Round Cover Cap (55) against the lower end of the axle. The teeth on the Retainers must bend toward the Round Cover Cap (see inset drawing). Tap the Retainers and Round Cover Cap onto the axle. Attach the other Arm (46) to the Arm Frame (52) in the same manner. Insert the two 4 1/2" "L" Pins (60) down through the indicated holes in the Arm Frame (52) and the Arms (46). 12 52-Lubricate 54 42 44 44 55 46 44 60 54 46 13. Wet both Arms (46) with soapy water. Slide a 7 3/4" Pad (45) onto each Arm. Press a 1" Round Inner Cap (49) into the indicated end of a 7" Handle (47). Wet the other end of the Handle with soapy water and slide a Handgrip (12) onto it. Insert the Handle into one of the Arms (46). Attach the Handle with a 5/16" x 2 1/4" Bolt (33), two 5/16" Flat Washers (8), a 1/2" x 3/8" Spacer (51) and a 5/16" Nylon Locknut (3). Attach a 7" Handle (47) to the other Arm (46) in the same manner. 13 46 45 47 44 52 54 55 8 3 46 47 12 49 8 51 45 33 14. Attach a Large "U" Bracket (56) to one of the Arms (46) with a 3/8" x 2 3/4" Bolt (70), 3/8" Flat Washer 14 (9), and 3/8" Nylon Locknut (21). Be sure that the Cable Trap (59) is on the side shown. Attach a Large "U" Bracket (56) to the other Arm (46) in the same manner. 8 59 21 56 59 46 21 9 56 9 70 70 46