Weslo 605 Instruction Manual - Page 7

7. Identify the Left Pedal Arm (11), which is marked with a sticker. Attach a Pedal (13) to the Left Pedal Arm with 7 two M6 x 48mm Flat Head Screws (36). Attach the other Pedal to the Right Pedal Arm (not shown) in the same way. 36 13 11 8. Apply a small amount of grease to the axle on the left 8 Disc Crossbar (16). Slide the Left Pedal Arm (11) onto the axle and place a Wave Washer (55) on the end of the axle. Next, slide an M10 Washer (35) onto an M10 x 25mm Patch Screw (22), and tighten the Patch Screw into the axle. Apply grease to a Pedal Arm Bolt Set (40). Then, hold the lower end of the left Handlebar Arm (5) inside the 5 bracket on the Left Pedal Arm (11). Attach the Left Pedal Arm to the left Handlebar Arm with the Bolt Set. Do not overtighten the Bolt Set; the Handlebar Arm must pivot freely. 16 Grease Attach the Right Pedal Arm (not shown) to the right Grease 40 side of the elliptical exerciser in the same way. See step 5. Tighten the M10 x 68mm Button Bolts (48). See step 6. Tighten the M6 x 36mm Button Bolts (50) in the Handlebar Arms (5). 40 11 55 22 35 9. Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the elliptical exerciser. 7