Whirlpool WDT730HAM Installation Instructions - Page 16
Install Door Handle (on some models), Place Dishwasher in Cabinet, Install door handle
View all Whirlpool WDT730HAM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Install Door Handle (on some models) 29. Install door handle D A Place Dishwasher in Cabinet WARNING Excessive Weight Hazard C Use two or more people to move and install or uninstall appliance. Failure to do so can result in back or other injury. 30. Stand dishwasher upright B A. Setscrew (in bottom of handle) B. Hex key C. Handle D. Mounting stud IMPORTANT: Do not scratch the front panel during this procedure. If door panel has a protective film, peel film back past the point of the handle studs before installing handle. Handle is easiest to install while unit is on its back. Remove the door handle and hex key from the packaging. Setscrews are already installed in the handle. Place handle on mounting studs with the setscrews facing down. Push the door handle tightly against the door. Insert the short end of the hex key into the setscrews. Tighten the setscrews 1/4 turn past snug. Retain hex key with Owner's Manual. Using 2 or more people, stand the dishwasher up. NOTE: Do not install kick plate until instructed to do so. IMPORTANT: If wheels were removed, cover the floor when moving the dishwasher. Slowly move dishwasher completely into cabinet opening. Do not kink or pinch water line, drain hose, power cord, or direct wire between dishwasher and cabinet. Remove cardboard from under dishwasher. It is all right if dishwasher fits tightly into cabinet opening. Do not remove insulation blanket-the blanket reduces the sound level. NOTE: Route water supply, drain hose, and power cord out the rear of the dishwasher. 31. Move dishwasher close to cabinet opening A B A. Water line B. Cable C C. Drain hose Route the utilities through the holes in the cabinet and pull the slack out at the same time as the dishwasher is pushed into the cabinet. 16