Whirlpool WDT730HAM Installation Instructions - Page 24
Complete Installation, Install Access Panel, Power supply cord - Plug into a grounded 3, prong outlet
View all Whirlpool WDT730HAM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Complete Installation Check that the power supply wire or cord does not touch dishwasher motor or the lower part of the dishwasher tub. WARNING Install Access Panel - For Plastic, begin with step 60 - For Metal, begin with step 63 Plastic Panel: 60. Reinstall access panel and fasteners A Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. 58. Power supply cord - Plug into a grounded 3 prong outlet A. Insulation (on some models) Place the plastic access panel against the dishwasher leg. Make sure insulation does not interfere with the float assembly. 61. Check access panel edge Plug into a grounded 3-prong outlet. 59. Reconnect power Reconnect electrical power at the fuse box or circuit breaker box. NOTE: With the access panel off, start the dishwasher and allow it to complete the shortest wash cycle. After the first 2 minutes, unlatch door, wait 5 seconds, and then open door. Check that there is water in the bottom of the dishwasher tub. Check that dishwasher is working properly Check that the lower edge of the access panel touches the floor. Adjust if necessary. 62. Tighten fasteners A 1/4 tCurn B A. Unlocked B. Locked C. 1/4 turn Using a flat-blade screwdriver, turn the fasteners 1/4 turn clockwise to lock into place. The fastener slot will be straight up and down when properly locked. Go to step 65. 24