Whirlpool WDT730HAM Installation Instructions - Page 22

Option A: Waste disposer - no air gap, Helpful Tip

Get Whirlpool WDT730HAM PDF manuals and user guides View all Whirlpool WDT730HAM manuals
Add to My Manuals
Save this manual to your list of manuals

Page 22 highlights

Option A: Waste disposer - no air gap A D C Option B: No waste disposer - no air gap D A C B A. Disposer inlet B. Drain trap C. Drain hose D. Large drain hose clamp Helpful Tip: Remove disposer knockout plug. 1. Using a hammer and screwdriver, 1 knock plug into disposer. 2. Use needle-nose pliers to remove plug. 2 3. Attach drain hose to disposer inlet with 3 large drain hose clamp (provided). Use pliers to squeeze clamp open and move into position. B A. Waste tee B. Drain trap C. Drain hose D. Large drain hose clamp 1. Fit rubber end (A) of drain hose to 1 waste tee and cut if needed. NOTE: Do not cut ribbed section. A 2 2. Attach rubber end of drain hose to waste tee with a large drain hose clamp (provided). Use pliers to squeeze clamp open and move into position. If the drain hose was cut, use a 11/2" to 2" (38 mm to 50 mm) screw-type clamp (not provided). 22

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
22
Option A: Waste disposer – no air gap
A
B
C
D
A. Disposer inlet
B. Drain trap
C. Drain hose
D. Large drain hose clamp
Helpful Tip:
Remove disposer knockout plug.
1
1.
Using a hammer and screwdriver,
knock plug into disposer.
2
2.
Use needle-nose pliers to remove plug.
3
3.
Attach drain hose to disposer inlet with
large drain hose clamp (provided). Use
pliers to squeeze clamp open and move
into position.
Option B: No waste disposer – no air gap
A
B
C
D
A. Waste tee
B. Drain trap
C. Drain hose
D. Large drain hose clamp
A
1
1.
Fit rubber end (A) of drain hose to
waste tee and cut if needed.
NOTE:
Do not cut ribbed section.
2
2.
Attach rubber end of drain hose to
waste tee with a large drain hose clamp
(provided). Use pliers to squeeze clamp
open and move into position. If the
drain hose was cut, use a 1
1
/
2
" to 2"
(38 mm to 50 mm) screw-type clamp
(not provided).