Whirlpool WED6600VU Use and Care Manual - Page 20

To make changes during an Automatic Cycle: • Press PAUSE/CANCEL • Adjust Dryness. DRYNESS NOTE: Dryness selections can be made only while using Automatic Cycles. Now the AccelerCare TM Drying System Works Moisture-sensing strips and temperature sensors inside the dryer drum monitor how fast the load is drying, how hot the air should be and when clothes are dry, The system automatically stops the cycle to help save time and avoid overdrying. To use a Timed Cycle Turn knob to desired Timed Cycle. Press the TIME ADJUST up or down arrows until the desired drying time is displayed. Press the up or down arrows and the time will change by 1-minute intervals. Press and hold the up or down arrows and the time will change by 5-minute intervals, NOTE: The Time Adjust features can be used only with the Timed Dry and the Enhanced Touch Up cycles. TIMEADJUST • Press TEMP until the desired temperature illuminates. To use a Steam Cycle (Quick Refresh and Enhanced Touch Up) • Press POWER. Turn the knob to select either the Enhanced Touch Up or the Quick Refresh cycles. Press the TIME ADJUST up or down arrows until the desired drying time is displayed. Press the up or down arrows and the time will change by 1-minute intervals. Press and hold the up or down arrows and the time will change by 5-minute intervals. NOTE: The Time Adjust features can be used only with the Timed Dry and the Enhanced Touch Up cycles, TIMEADJUST • Press TEMP until the desired temperature illuminates. T£MP NOTE: The Temp feature can be used only with the Timed Dry and the Enhanced Touch Up cycles. Only the Medium and High temperature settings can be used for the Enhanced Touch Up Cycle. NOTE: During the Enhanced Touch Up cycle, you can change the settings for Time Adjust and Temp. Open the door or press PAUSE/CANCEL once to pause the cycle, or press PAUSE/CANCEL twice to cancel a cycle. TEMP NOTE: The Temp feature can be used only with the Timed Dry and the Enhanced Touch Up cycles. NOTE: During theTimed Dry Cycle, you can change the settings for Time, Temp, the WRINKLE SHIELD TM setting and the End of Cycle Signal. 5. (OPTIONAL STEP) If desired, select OPTIONS. For more details, see "Options." 6. (OPTIONAL STEP) If desired, press END OF CYCLE SIGNAL, A signal will sound to alert you when a cycle ends. For more details, see "End of Cycle Signal." 7. Press START. Be sure the door is closed. • If you do not press Start within 5 minutes of selecting the cycle, the dryer automatically shuts off. • If you wish to end your drying cycle after pressing Start, press PAUSE/CANCEL twice. To stop or pause your dryer at any time Open the door or press PAUSE/CANCEL once. Press PAUSE/ CANCEL twice to cancel a cycle. To restart the dryer Close the door. Press START until dryer starts. NOTE: Drying will continue from where the cycle was interrupted if you close the door and press Start within 5 minutes. If the cycle is interrupted for more than 5 minutes, the dryer will shut off. Select new cycle settings before restarting the dryer. Select the correct cycle and dryness level or temperature for your load. If an Automatic Cycle is running, the display shows the estimated cycle time when your dryer is automatically sensing the dryness level of your load. If a Timed Cycle is running, the display shows the exact number of minutes remaining in the cycle. Cool Down tumbles the load without heat during the last few minutes of all cycles, Cool Down makes the loads easier to handle and reduces wrinkling. The length of the Cool Down depends on the load size and dryness level. 2O