Whirlpool WRF995FIFZ Use & Care Guide - Page 24
NOTES, IMPORTANT, To Dispense Water - Standard, To Dispense Water - Measured Fill, Units
View all Whirlpool WRF995FIFZ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Dispensing Touch CUBED ICE or CRUSHED ICE for your ice selection. NOTES: ■■ For crushed ice, cubes are crushed before being dispensed. This may cause a slight delay when dispensing crushed ice. Noise from the ice crusher is normal and pieces of ice may vary in size. ■■ When changing from crushed to cubed, a few ounces of crushed ice will be dispensed along with the first cubes. Dispensing Water IMPORTANT: ■■ Dispense at least 1 qt (1 L) of water every week to maintain a fresh supply. ■■ If the flow of water from the dispenser decreases, it could be caused by low water pressure. ■■ With the water filter removed, dispense 1 cup (237 mL) of water. If 1 cup (237 mL) of water is dispensed in 8 seconds or less, the water pressure to the refrigerator meets the minimum requirement. ■■ If it takes longer than 8 seconds to dispense 1 cup (237 mL) of water, the water pressure to the refrigerator is lower than recommended. See "Water Supply Requirements" and "Troubleshooting" sections for suggestions. To Dispense Water - Standard: 1. Press a sturdy glass against the water dispenser paddle. 2. Remove the glass to stop dispensing. NOTE: The Measured Fill button does not enable standard dispensing. It only functions in Measured Fill mode (see below). To Dispense Water - Measured Fill: Measured Fill allows you to dispense a specified amount of water with the touch of a few buttons. 1. Put a sturdy glass under waterspout. Touch MEASURED FILL to activate. NOTE: The amount of water you select will be dispensed. Make sure the container can hold the entire volume. If ice is in the container, you may need to adjust your selection. 2. Touch MEASURED FILL to turn on, then touch to select 8 oz (0.2 L), 16 oz (0.5 L), or 24 oz (0.7 L). Touch a fourth time to exit Measured Fill display. 3. Touch FILL (center ring button) and the selected amount of water will be dispensed. NOTES: ■■ The Measured Fill dispenser will automatically time out after 1 minute of inactivity. ■■ You can refill several glasses with the same measurement by continuing to touch FILL (center ring button) after each glass fill. Measured Fill Options are listed in the following chart: Units Ounces 8 16 24 Cups 1 2 3 Liters 0.2 0.5 0.7 NOTES: ■■ Most coffee cups (commonly 4 to 6 oz [118 to 177 mL] per cup) are not the same size as a measuring cup (8 oz [237 mL]). You may need to recalibrate Measured Fill to underfill or to avoid unintentionally overfilling coffee cups. 4. Dispense water. NOTE: While dispensing water, the center light circle will fill in. The flow of water will automatically stop once the desired volume has been dispensed. ■■ Press a sturdy glass against the dispenser paddle below the water spout. OR ■■ Place the glass below the waterspout and touch FILL for hands-free dispensing. 5. To stop dispensing before the selected volume has been dispensed, touch FILL a second time or touch the water dispenser paddle. NOTE: If you stop dispensing before the desired volume has been dispensed, the center light circle will continue to reflect how much water remains to be dispensed. The display will turn off after 1 minute of inactivity. 6. To select a new volume or start dispensing the same volume again, you must first finish dispensing the selected volume or turn off the Measured Fill feature (either by waiting 1 minute so it will automatically turn off or by touching CUBED ICE or CRUSHED ICE to manually turn it off), and then select Measured Fill again. 24