Xerox DC240 Customer Release Notes for built-in Fiery Network Controller for D - Page 5

Network Page 5 SNMP limitations If you change the community name or disable SNMP, WebSetup does not work. Power the device off, then on when you make a change to the SNMP tab in More Setup. If you disable SNMP, the automatic search for the Fiery feature in Command WorkStation, which is based on SNMP, does not work. If you disable SNMP, the following features are affected: • Two-Way communication • All Fiery applications that search for Fiery controllers using SNMP (Command WorkStation, Remote Scan, and Downloader) • Xerox CentreWare • Xerox MIBs Login Window for SNMP After you change and save the community name, a Login window appears. To validate the changes, enter "Admin" as the User Name and the Administrator password in Command WorkStation as the Password. Ethernet speed The Ethernet speed setting under Network Setup on the copier Control Panel lists two choices that are not supported: 10BASE-TX (Full Duplex) and 100BASE-TX (Full Duplex). It does not list a choice for a 1-Gbit speed. Use WebSetup if you want to set the speed to 1 Gbit. Novell network If the Fiery is connected to the Novell server through a switch and you experience connection problems, it might be because of the default port configuration of the switch. For example, if you have a Cisco 2950 switch, you must configure the port connected to the Fiery and the port connected to the Novell server as follows, to allow unimpeded traffic between the two. interface FastEthernet0/2 switchport mode access no ip address spanning-tree portfast interface FastEthernet0/6 switchport mode access no ip address spanning-tree portfast Part Number: 45045321