Xerox M123 System Administration Guide - Page 68
EtherTalk Environments, EtherTalk Installation, Installation Procedure, Network Communication Setup - mac
View all Xerox M123 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 68 highlights
5 EtherTalk EtherTalk Environments System configuration As the machine supports EtherTalk protocol, you can print from Macintosh. NOTE: You will need the optional PostScript Kit to use EtherTalk for printing. Target computers The machine supports a Macintosh or Power Macintosh with the following OS: • Mac OS 7.5 or later, 8.x, 9.x, or Mac OS X 10.2. EtherTalk Installation This section describes the installation procedure for using the machine in an EtherTalk Environment. Installation Procedure There are three stages required to install the machine on an EtherTalk network. Network Communication Setup This requires the machine to be set up for EtherTalk. Workstation Setup Install the print driver (Adobe PS) for Macintosh. Test Print A test print should be submitted to make sure that the machine has been installed and configured correctly. Network Communication Setup This procedure is used to set up the network communication parameters of the machine. At the machine, perform these steps. NOTE: Keep the SNMP port enabled while you use the machine on the TCP/IP network. NOTE: CentreWare Internet Services can also be used to configure the machine. Refer to the CentreWare Internet Services chapter of the User Guide. 68 Xerox CopyCentre/WorkCentre/WorkCentre Pro 123/128/133 System Administration Guide