Yamaha AV-1 Owner's Manual - Page 27

English ADJUSTMENTS BEFORE LISTENING OPERATIONS SETTING THE CLOCK 1 MEMORY AUTO/MAN'L PRESET/BAND DISPLAY TIME ADJ TIMER / HOUR / MIN REPEAT 2 MEMORY AUTO/MAN'L PRESET/BAND DISPLAY TIME ADJ TIMER / / HOUR MIN RDS MODE RDS START REPEAT FREQ PS/PTY/RT/CT 3 MEMORY AUTO/MAN'L PRESET/BAND DISPLAY TIME ADJ TIMER / / HOUR MIN RDS MODE RDS START REPEAT FREQ PS/PTY/RT/CT Changes Changes 1 While the power is on, press the DISPLAY button to display the time. If this system is in the standby mode, you can proceed to the next step. 2 While holding the TIME ADJ button pressed, press the HOUR button and set the hour. * Press the HOUR button once to advance the time by 1 hour. Press and hold to advance continuously. 3 While holding the TIME ADJ button pressed, press the MIN button and set the minute. * Press the MIN button once to advance the time by 1 minute. Press and hold to advance continuously. * The hour setting will not advance even if minute is advanced from "59" to "00". Europe, U.K., Australia and Singapore models use a 24-hour display. U.S.A. and Canada models use a 12-hour display shown by "AM (PM) 12:00". For General model, either the 24-hour display or the 12-hour display is selected depending on the setting of the FREQUENCY STEP switch on the rear panel, so you cannot select a desired type freely. In the event of a power failure or when the AC supply lead is disconnected. The time display will go out, however, the clock will function for about 5 minutes without power supply. So you do not have to reset the time if the AC power supply is resumed within about 5 minutes. When the AC power supply is resumed after more than 5 minutes pass without power supply, the time display will flash on and off to indicate that the time must be reset. ADJUSTING BRIGHTNESS OF THE DISPLAY If desired, you can adjust brightness of the display. 1 Press and hold the DISPLAY button for more than 2 seconds so that "DIMMER±0" appears on the display. 2 Holding the DISPLAY button pressed, press the " / " button once or more to increase or press the " / " button once or more to decrease brightness. This adjustment can be made even though this system is in the standby mode. Control range When the power is on: ±0 to -6 (Preset value: ±0) In the standby mode: +3 to -3 (Preset value: ±0) E-25