Yamaha CLP-380 Owner's Manual - Page 110
Appendix, Troubleshooting
View all Yamaha CLP-380 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 110 highlights
Appendix Appendix Troubleshooting Problem Cause Solution The power of the Clavinova does not turn on. The power cable is not plugged in (check at the Clavinova and at the electrical outlet). Insert the power cable plug firmly into the Clavinova and into the electrical outlet of the correct voltage (page 15). There is a clicking noise when you press the [POWER] button to turn the power on or off. This is caused by the electrical power within the instrument. This is not a malfunction. Noise is heard from the Clavinova. A portable telephone is being used near the Clavinova (or the ring tone is sounding). Turn off the power of the portable telephone located near the Clavinova. Noise may be heard if a portable telephone is used near the Clavinova or if the ring tone occurs. The overall volume is too low. Or, there is no sound at all. The [MASTER VOLUME] dial is lowered. Raise the [MASTER VOLUME] dial (page 16). The volume level for the keyboard performance is set too low. Move the [SONG BALANCE] slider toward the keyboard to increase the keyboard volume. Headphones are connected (only if the Speaker setting is "Normal HeadphoneSW") (page 99). Disconnect the headphone plug. Speaker setting is off. Set [Speaker] to "Normal" or "ON" (page 99). Local Control is turned off. Set Local Control ON (page 100). "Expression" is assigned to the right Assign any function other than pedal or the AUX pedal. "Expression" to the pedal. The keyboard volume is lower than the song playback volume. The volume level for the keyboard performance is set too low. Move the [SONG BALANCE] slider toward the keyboard to increase the keyboard volume. Sound is still heard from the speakers even though headphones are plugged in. Speaker setting is On. Set the speaker setting to "Normal (HeadphoneSW)" (page 99). The tone quality and/or volume from the speaker or headphones has changed. Plugs are connected to the AUX OUT jacks. Disconnect the plugs. Feedback occurs when you turn iAFC on. iAFC was not automatically adjusted Turn iAFC OFF, and perform the correctly. automatic adjustment (page 93). Damper pedal does not function. The plug of the pedal cable is not inserted into the [PEDAL] jack. Plug the pedal cable firmly into the [PEDAL] jack. (Refer to "Keyboard Stand Assembly" beginning on page 117.) 110 CLP-380 Owner's Manual