Yamaha D2040 D2040 Owners Manual Image - Page 10

Displays (2) CLIP Indicators L and R This indicator lights up when the signal level is clipped within the digital signal processing unit of the corresponding channel. When this indicator lights up, adjustments can be made by putting the unit in parameter edit mode and using the D. ATT C) or LIMIT/COMP iz keys to decrease the level, or by changing the PEQ C) setting. @ Input Signal Level Meter This meter shows the level of the incoming analog or digital signal. Note that there is no clip margin so it is necessary to pay close attention to the input signal level setting. If the CLIP indicator n) lights up, the input level is too high. C) Operating Mode Indicators These indicators show the status and settings of utility modes and the protect switch of the rear panel O. INPUT: Digital Input Display AES/EBU is on Digital input, signal format is AES/EBU Y2 is on Digital input, signal format is YAMAHA Y2 Both are off Analog input Fs: Sampling Frequency Display 48 kHz is on Sampling frequency is 48 kHz 44.1 kHz is on Sampling frequency is 44.1 kHz 32 kHz is on Sampling frequency is 32 kHz All are off Analog input, or (Digital input, input phasing is excessively off. Check signal format, connections, etc.) EMPHASIS is on Emphasis has been set. PROTECT: Rear Panel Switch C) MEMORY is on Disables writing to memory and title editing. KEY is on Disables all key and switch operation except for power switch t. 0) Memory Number LED (7 segment) Displays number of memory currently under selection. Display blinks when corresponding memory contents are enabled for recall or writing. LCD Screen All parameters are displayed on the LCD screen. Other Power Switch Turns power on or off. When turned on, all parameters and controls return to the state they were in previous to the last shut down. 9