Yamaha D2040 D2040 Owners Manual Image - Page 9

Fader Link Selection C) FADER LINK Key When the red LED of this key is on, all output controls (®, C)) are adjusted instantly in one of two ways: (A) When one UR red LED ® )s on and the other is blinking, all output controls are linked with and operate in relation to the operation of the L control of channel 1. (B) When one UR red LED ® is on and the other is off, all L output controls will be adjusted to the position of the L control of channel 1, and all R output controls are linked with and operate in relation to the operation of the R control of channel 1 In either case, when adjustments are made to any controls other than the channel 1 control, they will return to their respective previous positions set by the fader link. Utility Selection C) UTILITY Key When the red LED of this key is on the unit is in utility mode. When in utility mode it is not possible to recall memory data or edit parameters. Each time this key is pressed, a different utility category is displayed on the LCD screen Z. The memory up/down memory keys) can also be used to change the utility categories under selection. To exit the utility mode, press this key for more than 1 second or press any key from n) to C). Output Controls C) L output Controls This control will set the output signal level of the L side of its corresponding divider channel. The position of the control can be registered as a parameter and recorded in memory. When this parameter is recalled, because the control is driven by an electric motor, it is automatically reset to the position designated by the recalled parameter. When the red LED of the FADER LINK key C) is on, the L controls of all channels are automatically linked and operate in relation to the operation of the L control of channel 1. to R Output Controls This control will set the output signal level of the R side of its corresponding divider channel. The position of the control can be registered as a parameter and recorded in memory. When this parameter is recalled, because the control is driven by an electric motor, it is automatically reset to the position designated by the recalled parameter. When the red LED of the FADER LINK key C) is on, the R controls of all channels are automatically linked and operate in relation to the operation of the R control of channel 1. Parameter Selection C) PEO/D.ATT (parametric equalizer/digital attenuator) Key Press this key to enter parameter edit mode. Each time this key is pressed the parametric equalizer 1 or 2 and the digital attenuator parameters are displayed on the LCD screen C) accordingly. © LIMIT/COMP (limiter/compressor) Key Press this key to enter parameter edit mode. Each time this key is pressed the limiter/compressor parameters are displayed on the LCD screen 8 accordingly. C) DELAY/POLARITY Key Press this key to enter parameter edit mode. Each time this key is pressed the channel delay, offset delay, a and polarity parameters are displayed on the LCD screen accordingly. Q FILTER Key Press this key to enter parameter edit mode. Each time this key is pressed the high pass filter and low pass a filter parameters are displayed on the LCD screen accordingly. Channel Muting @ MUTE L Keys These keys are used to mute the L side of the corresponding channel. If the software protect operation set in utility mode is not on, this key can be used mute output at the operator's discretion. This key comes in handy when adjusting the speaker for each channel. C) MUTE R Keys These keys are used to mute the R side of the corresponding channel. If the software protect operation set in utility mode is not on, this key can be used mute output at the operator's discretion. This key comes in handy when adjusting the speaker for each channel. 8