Yamaha DGC1B Disklavier Mark III Series DGC1B Basic Operation Manual - Page 24

Turning On/Off Your Disklavier, Turning On the Disklavier, Turning Off the Disklavier

Page 24 highlights

Chapter 4 Turning On/Off Your Disklavier This chapter describes how to turn on and off your Disklavier and how to set the internal calendar. Turning your Disklavier on/off is a basic and very important procedure. Always be sure to follow the procedure described below when you turn on or off your Disklavier. Turning On the Disklavier 1 Set the MAINS switch to ON. Turning Off the Disklavier 1 Press [STANDBY / ON] on the Control Unit. MAINS ON OFF 2 Press [STANDBY / ON] on the front panel of the Control Unit. DRIVE SELECT CONTROL UNIT DKC60RCD PLAY/PAUSE OSTNANDBY STOP REC SONG SELECT/REV • FWD PART L R ENTER VOICE FUN The following message appears on the display. Your Disklavier is now ready for use. 2 Set the MAINS switch to OFF. Setting the MAINS switch to OFF is effectively the same as disconnecting the power cable from an AC wall outlet. If the Disklavier is used regularly, you only need to use the [STANDBY / ON] button on the Control Unit. If the Disklavier is not going to be used for a long period, set the MAINS switch to OFF. When the Disklavier is turned off, wait at least 5 seconds before turning it on again. Note: The MAINS switch only needs to be switched off when you are not going to use the Disklavier for a long period of time. For daily use, only the [STANDBY / ON] button on the Control Unit needs to be turned on and off. 12

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74

12
This chapter describes how to turn on and off your Disklavier and how to set the internal calendar.
Turning your Disklavier on/off is a basic and very important procedure.
Always be sure to follow the
procedure described below when you turn on or off your Disklavier.
Turning On the
Disklavier
1
Set the MAINS switch to ON.
2
Press [STANDBY / ON] on the
front panel of the Control Unit.
The following message appears on the
display.
Your Disklavier is now ready for use.
Turning Off the
Disklavier
1
Press [STANDBY / ON] on the
Control Unit.
2
Set the MAINS switch to OFF.
Setting the MAINS switch to OFF is
effectively the same as disconnecting the
power cable from an AC wall outlet.
If the
Disklavier is used regularly, you only need
to use the [STANDBY / ON] button on the
Control Unit.
If the Disklavier is not going
to be used for a long period, set the MAINS
switch to OFF.
When the Disklavier is turned off, wait at
least 5 seconds before turning it on again.
Note:
The MAINS switch only needs to be
switched off when you are not going to
use the Disklavier for a long period of
time.
For daily use, only the
[STANDBY / ON] button on the
Control Unit needs to be turned on and
off.
Chapter 4
Turning On/Off Your Disklavier
PLAY/PAUSE
STOP
REC
SONG SELECT
/
REV • FWD
PART
L
R
ENTER
VOICE
FUN
CONTROL UNIT DKC60RCD
STANDBY
ON
SELECT
DRIVE
MAINS
OFF
ON