Yamaha DGC1B Disklavier Mark III Series DGC1B Basic Operation Manual - Page 44
Starting Playback from a Specified Point (Search), Press [SEARCH]., Enter the time that you want
View all Yamaha DGC1B manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
Starting Playback from a Specified Point (Search) Playback can be started from a specified point in a song. Instead of using fast forward or preview, you can use this function to go directly to a desired point within a song. If the current song uses the minutes and seconds time format, you specify the point in minutes and seconds. If it uses the measures and beats time format, you specify the point in measures and beats. Once a time value has been entered, it is saved until the disk is ejected or the Disklavier is turned off. If you want to search for the same point again, just press the search button again. 1 Press [SEARCH]. SEARCH Remote Control The time counter on the display flashes. Flashes If the time value is less than 10, that is, between 00:01 and 09:59, remember to press [0] first to set the first digit to zero. If you enter a value higher than the entire song time, the search goes to the end of the song. 3 Press [SEARCH] again to begin the search. SEARCH Remote Control If the Disklavier was already playing when you pressed [SEARCH], playback will continue from the new point when the search is complete. If the Disklavier was not playing, Pause mode is engaged when the search is complete. To search for a new point, repeat step 2. 2 Enter the time that you want to search for. For example, to search for 2:56, first press [2], then [5], then [6]. SEARCH 1 2 3 DRIVE 4 5 6 7 8 9 0 Remote Control 32