Yamaha DTX-PROX DTX-PRO DTX-PROX Reference Manual - Page 137

Troubleshooting Symptom No sound Out of balance No sound Possible cause DTX-PRO Solution DTX-PROX The cable is not properly connected • Ensure that the PRO series module is properly connected to headphones or an external audio system, such as an amplifier and/or speakers. • Ensure that the cables you are using are in good condition. Pad settings have not been properly configured Turn the "PadFunction" setting in MENU/Utility/Pad "off." Trigger settings are improper • Check the "Pad Type" parameter from MENU/Trigger/Pad Type or TRIGGER/SETTING/Pad Type. • Check the "Velocity Curve" parameter from MENU/Trigger/ Curve or TRIGGER/SETTING/Curve, and the "Gain" parameter from MENU/Trigger/Pad Type or TRIGGER/SETTING/Pad Type. • Ensure that the "Minimum Level" parameter from MENU/Trigger/Pad Type or TRIGGER/SETTING/Pad Type has not been set too high, as this can prevent sound from being output. • Check the settings in MENU/Trigger/Input Mode or TRIGGER/ SETTING/Input Mode. Filter and decay settings have not been properly configured • If using filters, re-adjust your VoiceFilter settings as they often prevent sound from being output. • Check the VoiceFilter and VoiceDecay settings in MENU/Kit Edit/Voice. MIDI settings have not been properly configured • Ensure that the "MessageType" parameter from MENU/Kit Edit/ Kit Modifier/Voice is set to "note." • When the "MessageType" parameter from MENU/Kit Edit/Kit Modifier/Voice is set to "note," the sound will not play if the "Voice Number" parameter from MENU/Kit Edit/Kit Modifier/ Voice is set to "no assign." • Ensure that the "VelLo" parameter from MENU/Kit Edit/Kit Modifier/Voice/MessageType is not set too high. Pads will produce sound only when struck harder than the value set here. • Ensure that the "TrgVel" parameter from MENU/Kit Edit/Kit Modifier/Voice/MessageType is not set too low. Low trigger velocities result in low output volumes. • Ensure that the "MIDI LocalCtrl" parameter from MENU/Utility/ General is set to "on." The volume or level settings are improper The headphone volume is not turned up The metronome volume is not turned up Check the following: • Volume controllers on amplifiers and/or speakers connected to the PRO series module. • MENU/Kit Edit/Volume • The trigger output level of any pads with a dial allowing this to be adjusted. • The [MASTER VOLUME] knob on the DTX-PRO front panel. • The sliders on the MIXER screen. • Volume for the metronome (Click). ([CLICK VOLUME] knob) • Sliders ([OUTPUT] and [PHONES]) on the DTXPROX top panel. • LED rotary faders • Volume for the metronome (Click) ([CLICK] slider). DTX-PRO DTX-PROX Reference Manual 137