Yamaha DTX-PROX DTX-PRO DTX-PROX Reference Manual - Page 142

Troubleshooting Symptom Connected external device does not produce sound Possible cause The device is not connected properly The MIDI channels do not match A function has been assigned to the pad The pad volume is low Cannot exchange data with DAW applications Power turns off unexpectedly The PRO series module does not receive any switch or trigger signals at all I want to reset the PRO series module to the factory default Solution DTX-PRO DTX-PROX • Ensure that the MIDI cable has been correctly connected. • Ensure that the MIDI channels match. For more information on MIDI settings, see page 35. • When using a USB MIDI connection, ensure that USB cables have been correctly connected. • Pads that have been assigned a function will not play sound even when struck. Set the "Pad Function" in MENU/Utility/Pad to "off." • Ensure that the "MessageType" parameter from MENU/Kit Edit/ Voice is set to "note." Sounds will not be produced if this is not set to "note." • Ensure that the "VelLo" parameter from MENU/Kit Edit/Voice/ MessageType is not set too high. Pads will produce sound only when struck harder than the value set here. • Ensure that the "Minimum Level" parameter from MENU/Trigger/Pad Type or TRIGGER/SETTING/Pad Type has not been set too high, as this can prevent sound from being output. • When the Auto Power-Off function activates to turn off the PRO series module, any connection with DAW software will be lost. To restore this connection, close the DAW application, turn the PRO series module back on, and then launch the application once again. It is advisable to disable the Auto Power-Off function when exchanging data with a computer. • A driver is required to send audio data in Windows. (page 136) • Ensure that the USB cable has been correctly connected. Disable the Auto Power-Off function. Use the Factory Reset to restore the settings to the factory defaults. DTX-PRO DTX-PROX Reference Manual 142