Yamaha DTX-PROX DTX-PRO DTX-PROX Reference Manual - Page 140

Troubleshooting Symptom Pads are only producing sounds at very high volumes (i.e., high velocities) Possible cause Pads produce unintended sounds Sounds are distorted Sounds play endlessly and do not stop Effects cannot be applied The wave tempo does not change Pad controller does not work By pressing the [REC] button, only one song can be recorded. The previous recording is overwritten My training scores are strange Crosstalk is occurring Solution DTX-PRO DTX-PROX • Ensure that the "Gain" parameter from MENU/Trigger/Pad Type or TRIGGER/SETTING/Pad Type is not set too high. • Adjust the "Velocity Curve" parameter from MENU/Trigger/ Curve or TRIGGER/SETTING/Curve. • Check the "TrgVel" setting in MENU/Kit Edit/Kit Modifier/Voice/ MessageType. For example, if this parameter is set to "127," the maximum velocity will be produced even when the pad is struck lightly. • Ensure that you are using only the recommended Yamaha pads. Products from other manufacturers can output excessively large signals. • Ensure that trigger setups have been configured correctly. • If an external MIDI device played from the PRO series module does not produce the expected sounds, review its voice settings for the MIDI channel on which the PRO series module is sending data, and ensure that they are appropriate for the MIDI data being sent. • Voices assigned to layers B, C, or D may cause unintended sounds. • In some cases where unexpected sounds are produced when you have connected a two or three-zone pad to any of the [wTOM1/e], [rTOM2/t], [yTOM3/u], [!2KICK/!3], [qSNARE] or [!4] jacks. If so, with Pad 3, Pad 5, Pad 7 or Pad 13, set the "Pad Type" parameter to "off" in MENU/Trigger/Pad Type or TRIGGER/SETTING/Pad Type. With Pad 1 or Pad 14, select the proper pad type in MENU/Trigger/Pad Type or TRIGGER/SETTING/Pad Type. • Check the crosstalk setting, min level setting and sensitivity setting. • Ensure that effects have been set appropriately. Sound can be distorted with certain combinations of effect type and parameter settings. • Ensure that the "VoiceFilter" parameter in MENU/Kit Edit/Voice is configured properly. Depending on the VoiceQ settings (filter resonance), distortion can be caused. • Lower the PRO series module's master volume. Ensure that the hold function is not turned on. Press [EXIT] while on the kit screen (top screen) to stop the KIT sounds. • Ensure that the [EFFECT] knob is not turned down to minimum. • Ensure that the effect type is not set to "THRU" or "NO EFFECT." • Ensure that the InstSend value is high enough for Effect 1 or Effect 2. Effects may not be applied to the output via Indiv Out. Master effects will not be applied. Insertion effects may not be applied depending on the settings. Wave tempo cannot be changed. It will always play at the original tempo of the imported file regardless of kit tempo and other settings. Pad controllers are not supported. Only one song can be recorded to the PRO series modules. See the section on "Crosstalk." DTX-PRO DTX-PROX Reference Manual 140