Yamaha EZ-TP Owner's Manual - Page 6

Setting Up, Power Requirements

Get Yamaha EZ-TP PDF manuals and user guides View all Yamaha EZ-TP manuals
Add to My Manuals
Save this manual to your list of manuals

Page 6 highlights

Setting Up Power Requirements Although the instrument will run either from the supplied AC adaptor or optional batteries, Yamaha recommends use of an AC adaptor whenever possible. An AC adaptor is more environmentally friendly than batteries and does not deplete resources. ■ Using an AC Power Adaptor q Make sure that the [STANDBY/ON] switch of the instrument is set to STANDBY. WARNING • Use ONLY a Yamaha PA-3C AC Power Adaptor (or other adaptor specifically recommended by Yamaha) to power your instrument from the AC mains. The use of other adaptors may result in irreparable damage to both the adaptor and the instrument. w Connect the AC adaptor (PA-3C or other adaptor specifically recommended by Yamaha) to the power supply jack. e Plug the AC adaptor into an AC outlet. NOTE • Connecting the AC adaptor automatically supplies from the adaptor and battery even when batteries are installed. CAUTION • Unplug the AC Power Adaptor when not using the instrument, or during electrical storms. DC IN 12V AC adaptor PA-3C ■ Using the Batteries q Using a coin or screwdriver open the battery compartment located on the bottom of the instrument. w Insert four new alkaline batteries, being careful to follow the polarity markings as shown below. e Replace the compartment cover, making sure that it locks firmly in place. 6 EZ-TP Owner's Manual For battery operation the instrument requires four 1.5V "AA" size, LR6 or equivalent batteries. (Alkaline batteries are recommended.) When the batteries run low and the battery voltage drops below a certain level, the instrument may not sound or function properly. As soon as this happens, make sure to replace all batteries, following the precautions listed below. CAUTION • Be sure to observe the +/- polarity markings, and install the batteries with the proper orientation. Improper battery orientation can result in overheating, fluid leakage, and possibly fire. • When the batteries run down, replace them with a complete set of four new batteries. NEVER mix old and new batteries. Do not use different kinds of batteries (e.g. alkaline and manganese) at the same time. • If the instrument is not to be in use for a long time, remove the batteries from it, in order to prevent possible fluid leakage from the battery. • Always use the AC power adaptor when using the Song Filer application to load song data into the EZ-TP. The Song Filer will not function when battery power is used. 4

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
6
EZ-TP
Owner’s Manual
Setting Up
Although the instrument will run either from the supplied AC adaptor or optional
batteries, Yamaha recommends use of an AC adaptor whenever possible. An AC
adaptor is more environmentally friendly than batteries and does not deplete
resources.
■
Using an AC Power Adaptor
q
Make sure that the [STANDBY/ON] switch
of the instrument is set to STANDBY.
w
Connect the AC adaptor (PA-3C or other
adaptor specifically recommended by
Yamaha) to the power supply jack.
e
Plug the AC adaptor into an AC outlet.
■
Using the Batteries
q
Using a coin or screwdriver open the
battery compartment located on the bottom
of the instrument.
w
Insert four new alkaline batteries, being
careful to follow the polarity markings as
shown below.
e
Replace the compartment cover, making
sure that it locks firmly in place.
For battery operation the instrument requires
four 1.5V “AA” size, LR6 or equivalent bat-
teries. (Alkaline batteries are recommended.)
When the batteries run low and the battery
voltage drops below a certain level, the instru-
ment may not sound or function properly. As
soon as this happens, make sure to replace all
batteries, following the precautions listed
below.
Power Requirements
•
Use ONLY a Yamaha PA-3C AC Power Adaptor
(or other adaptor specifically recommended by
Yamaha) to power your instrument from the AC
mains. The use of other adaptors may result in
irreparable damage to both the adaptor and the
instrument.
•
Unplug the AC Power Adaptor when not using
the instrument, or during electrical storms.
WARNING
CAUTION
DC IN 12V
AC adaptor
PA-3C
NOTE
•
Connecting the AC adaptor automati-
cally supplies from the adaptor and bat-
tery even when batteries are installed.
•
Be sure to observe the +/- polarity markings,
and install the batteries with the proper orien-
tation. Improper battery orientation can result
in overheating, fluid leakage, and possibly fire.
•
When the batteries run down, replace them
with a complete set of four new batteries.
NEVER mix old and new batteries. Do not use
different kinds of batteries (e.g. alkaline and
manganese) at the same time.
•
If the instrument is not to be in use for a long
time, remove the batteries from it, in order to
prevent possible fluid leakage from the battery.
•
Always use the AC power adaptor when using
the Song Filer application to load song data
into the EZ-TP. The Song Filer will not function
when battery power is used.
CAUTION
4