Yamaha MT400 Owner's Manual - Page 10

9 Recorder Section LM N O TAPE SPEED CONTROL PITCH 4.8/ 9.5 - + ON OFF SYNC ZERO STOP ON OFF REC SELECT 1 2 3 4 OFF OFF OFF OFF L R L R NOISE REDUCTION SYSTEM PQ METER SELECT 4TR STEREO R S T L PITCH control This rotary control adjusts the tape speed in the range of ±10%. M Tape speed switch This switch is used to select 4.8 cm/second or 9.5 cm/second for the tape speed. Set the switch to 9.5 ( ) for normal recording, and 4.8 ( ) for playback of a tape recorded with a normal cassette tape recorder. N REC SELECT switches These switches are used to select recording sources for tracks. 1 - 4 ...Input channel (1-4) signals are routed directly to the corresponding tracks for recording (direct recording). OFF The corresponding tracks are disabled for recording. L/R The corresponding tracks are ready for recording and receive L channel (Tracks 1 and 3) or R channel (Tracks 2 and 4) signals. O METER SELECT switch This switch selects the signal level to be displayed on the level meters a. 4TR The level meters display the track input signal levels during recording and the track output signal levels during playback. STEREO....The level meters display the Stereo bus signal levels (signal output from the STEREO OUT jacks). P dbx switch Use this switch to turn on and off the dbx noise reduction system. ON The dbx noise reduction system is turned on for all tracks. OFF The dbx noise reduction system is turned off for all tracks. SYNC .........The dbx noise reduction system is turned off only for Track 4. Note: The SYNC setting is used for a special application in which Track 4 is used for synchronization. See page 41 for more information. -Owner's Manual