Yamaha MTX MTX/MRX system Firmware Update Guide - Page 10

■ Computer TCP/IP setting ( for device main), Choose [Internet Protocol Version 4 TCP/IPv4]

Get Yamaha MTX PDF manuals and user guides View all Yamaha MTX manuals
Add to My Manuals
Save this manual to your list of manuals

Page 10 highlights

Computer TCP/IP setting ( for device main) To update device main firmware, configure computer TCP/IP settings. If only a YDIF model is being updated, and the computer is already connected to the unit itself, there is no need to change the TCP/IP settings. Proceed to the next section "Updating the device main firmware." 1. Start up MTX-MRX Editor. The "User Account Control" dialog box may appear. Click [Continue] or [Yes]. 2. The "Network Setup" dialog box appears, click [Open Network Connection]. "Network Connections" will appear. You can also access the "Network Setup" dialog box by choosing [System] menu -> [Network Setup]. 3. Right-click the adapter to which the device(s) are connected, and choose [Properties]. The "Local Area Connection Properties" dialog box will appear. 4. Choose [Internet Protocol Version 4 (TCP/IPv4)], and then click [Properties]. The "Internet Protocol Version 4 (TCP/IPv4) Properties" dialog box will appear. 5. Click [Use the following IP address]. For a system in which a router or DHCP assigns the IP address, click [Obtain an IP address automatically ] and proceed to step 7. 6. Enter your computer's IP address "192.168.0.253" into [IP address], and "255.255.255.0" into [Subnet mask]. If there is a device whose UNIT ID is set to 0xFD, specify a value that does create a UNIT ID conflict. 7. Click [OK]. In some cases, Windows firewall may block MTX-MRX Editor when you make this setting. Select the [Private Network] check box, and click [Allow Access]. 10

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
10
■
Computer TCP/IP setting ( for device main)
To update device main firmware, configure computer TCP/IP settings.
If only a YDIF model is being updated, and the computer is already connected to the unit itself, there
is no need to change the TCP/IP settings. Proceed to the next section "Updating the device main
firmware."
1.
Start up MTX-MRX Editor.
・
The “User Account Control” dialog box may appear. Click [Continue] or [Yes].
2.
The “Network Setup” dialog box appears, click [Open Network Connection].
“Network Connections” will appear. You can also access the "Network Setup" dialog box by choosing [System]
menu -> [Network Setup].
3.
Right-click the adapter to which the device(s) are connected, and choose [Properties].
The “Local Area Connection Properties” dialog box will appear.
4.
Choose [Internet Protocol Version 4 (TCP/IPv4)], and then click [Properties].
The “Internet Protocol Version 4 (TCP/IPv4) Properties” dialog box will appear.
5.
Click [Use the following IP address].
For a system in which a router or DHCP assigns the IP address, click [Obtain an IP address automatically ] and
proceed to step 7.
6.
Enter your computer's IP address "192.168.0.253" into [IP address], and "255.255.255.0" into [Subnet
mask].
・
If there is a device whose UNIT ID is set to 0xFD, specify a value that does create a UNIT ID conflict.
7.
Click [OK].
・
In some cases, Windows firewall may block MTX-MRX Editor when you make this setting. Select the [Private
Network] check box, and click [Allow Access].