Yamaha MW10C MW8CX/MW10C Owners Manual - Page 18

Reference Front & Rear Panels Master Control Section 1 2 5 3 6 4 7 0 8 A 9 B C D MW8CX 1 2TR IN Jacks These RCA pin jacks can be used to input a stereo sound source. Use these jacks when you want to connect a CD player directly to the mixer. NOTE Select where you want to send the signal using the 2TR IN/USB switch B, and adjust the signal level using the 2TR IN/USB control in the Master Control section. 2 REC OUT (L, R) Jacks These RCA pin jacks can be connected to an external recorder such as an MD recorder in order to record the same signal that is being output via the STEREO OUT jacks. NOTE The mixer's STEREO Master control has no affect on the signal output via these jacks. Be sure to make appropriate level adjustments at the recording device. 3 RETURN L (MONO), R Jacks These are unbalanced phone-jack type line inputs. The signal received by these jacks is sent to the STEREO L/R bus. These jacks are typically used to receive the signal returned from an external effect device (reverb, delay, etc.). NOTE These jacks can also be used as an auxiliary stereo input. If you connect to the L (MONO) jack only, the mixer will recognize the signal as monaural and will send the identical signal to both the L and R jacks. 4 SEND EFFECT (AUX) Jack This is an impedance balanced* TRS phone jack that outputs the signal from the EFFECT (AUX) bus. You can use this jack, for example, to connect to an external effect unit. 5 STEREO OUT (L, R) Jacks These are impedance balanced* TRS phone jacks that output the signals adjusted by the STEREO Master control E. You can use these jacks, for example, to connect to the power amplifier driving your main speakers. 6 MONITOR (L, R) Jacks These are impedance balanced* TRS phone jacks that output the signals adjusted by the MONITOR/PHONES control C. Connect these jacks to your monitor system. 7 PHONES Jack Connect a pair of headphones to this TRS phone jack. The PHONES jack outputs the same signal as the MONITOR OUT jacks. 8 PHANTOM +48 V Switch This switch toggles phantom power on and off. When the switch is on the mixer supplies +48V phantom power to all channels that have XLR mic input jacks (CHs 1-5/6). Turn this switch on when using one or more phantom-powered condenser microphones. NOTE When this switch is on the mixer supplies DC +48 V power to pins 2 and 3 of all XLR-type MIC INPUT jacks. • Be sure to leave this switch off ( ) if you do not need phantom power. CAUTION • When turning the switch on ( ), be sure that only condenser mics are connected to the XLR input jacks (CHs: 1 to 5/6). Devices other than condenser mics may be damaged if connected to the phantom power supply. Note, however, that the switch may be left on when connecting to balanced dynamic microphones. • To avoid damage to speakers, be sure to turn off amplifiers (or powered speakers) before turning this switch on or off. We also recommend that you turn all output controls (STEREO Master control, etc.) to their minimum settings before operating the switch to avoid the risk of loud noises that could cause hearing loss or device damage. 18 MW8CX/MW10C Owner's Manual