Yamaha MW10C MW8CX/MW10C Owners Manual - Page 19

Reference Front & Rear Panels 9 RETURN Control Adjusts the level at which the signal received at the RETURN jacks (L (MONO) and R) is sent to the STEREO L/R bus. NOTE If you supply a signal to the RETURN L (MONO) jack only, the mixer sends the same signal to both the L and R Stereo buses. 0 POWER Indicator This indicator lights when the mixer's power is ON. A Level Meter This LED meter displays the level of the signal sent to the STEREO OUT jacks, MONITOR jacks and the PHONES jack. The "0" segment corresponds to the nominal output level. The PEAK segment lights red when the output reaches the clipping level. B 2TR IN/USB • 2TR IN/USB Switch If it is set to TO STEREO ( ), the signals input via the 2TR IN jacks and the USB connector are sent to the STEREO L/R bus. If this switch is set to TO MONITOR ( ), the signals are sent to the MONITOR OUT jacks, the PHONES jack, and the level meter. The MONITOR MIX feature becomes available when it is set to TO MONITOR ( ). * : When overdubbing, you can adjust the levels of the monitor playback signal and the signal being recorded separately. MONITOR MIX Signal Flow 2TR IN/ USB 2TR IN/USB control Playback signal MONITOR/PHONES controls STEREO Recording bus MONITOR/ PHONES jacks signal STEREO Master control REC OUT/USB • 2TR IN/USB control Adjusts the level of the signal sent from the 2TR IN jacks and USB connector to the STEREO L/R bus. C MONITOR/PHONES Control Controls the level of the signal output to the PHONES jack and the MONITOR jacks. D STEREO Master Control Adjusts the signal level sent to the STEREO OUT jacks. * Impedance Balanced Since the hot and cold terminals of impedance balanced output jacks have the same impedance, these outputs are less affected by induced noise. Jack List Input and Output Jacks Polarities MIC INPUT Pin 1: Ground Pin 2: Hot (+) Pin 3: Cold (-) LINE INPUT (stereo channels) STEREO OUT, MONITOR, EFFECT (AUX)* Tip: Hot (+) Ring: Cold (-) Sleeve: Ground INSERT Tip: Output Ring: Input Sleeve: Ground PHONES Tip: L Ring: R Sleeve: Ground Configurations INPUT OUTPUT XLR Connector Ring Sleeve Tip TRS Phone Connector RETURN LINE INPUT (monaural channels) Tip: Hot Sleeve: Ground Sleeve Tip Phone Connector * These jacks will also accept connection to monaural phone connectors. If you use monaural plugs, the connection will be unbalanced. MW8CX/MW10C Owner's Manual 19