Yamaha MX49 Owner's Manual - Page 42
Pitch or intervals are wrong., No effect is applied.
View all Yamaha MX49 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
Appendix Distorted sound. Are the effect settings appropriate? Use of certain effects at certain settings may produce distortion. [EDIT] Select "02:Part" [ENTER] Select "05:Voice Insert Eff"/"05:DrumKit Insert Eff" [ENTER] Are the filter settings appropriate? Excessively high filter resonance settings can cause distortion. [EDIT] Select "02:Part" [ENTER] Select "02:Filter/EG" [ENTER] Are any of the following volume parameters set so high that clipping is occurring? [UTILITY] [EDIT] Select "01:Common" [ENTER] Select "05:General" [ENTER] "Volume" [PART SELECT] "Volume" [UTILITY] Select "01:General" [ENTER] "WAV Volume" Sound is cut off. Is the entire amount of notes played (via your keyboard playback and Song/Pattern/Arpeggio playback) exceeding the maximum polyphony of this instrument? The maximum number of simultaneous notes may be less than 128 depending on the Voices used. Only one note sounds at a time. When this situation occurs, the Mono/Poly parameter in the current mode is set to "mono." If you wish to play chords, set this parameter to "poly." [EDIT] Select "02:Part" [ENTER] Select "01:PlayMode" [ENTER] "Mono/Poly" Pitch or intervals are wrong. Is the Master Tune parameter in the Utility display set to a value other than "0"? [UTILITY] Select "01:General" [ENTER] "Tune" Is the Note Shift parameter in the Utility display set to a value other than "0"? [UTILITY] Select "01:General" [ENTER] "NoteShift" Are the Note Shift and Detune parameters of each Part set to values other than "0"? [EDIT] Select "01:Part" [ENTER] Select "01:PlayMode" [ENTER] "NoteShift"/"Detune" No effect is applied. Check the on/off status of the Insertion Effect switch. [EDIT] Select "02:Part" [ENTER] Select "01:PlayMode" [ENTER] "InsSw" [PART SELECT] "InsSw" Is the Reverb Send or Chorus Send set to a value other than "0"? [EDIT] Select "02:Part" [ENTER] Select "01:PlayMode" [ENTER] "ChoSend"/"RevSend" Has the Insertion Effect type for the Part been set to "thru"? [EDIT] Select "02:Part" [ENTER] Select "05:Voice Insert Eff"/"05:DrumKit Insert Eff" [ENTER] The Edit Indicator appears, even when parameters are not being edited. Keep in mind that even though the Edit mode is not active, simply moving a Knob or playing back the MIDI data of the USB flash memory may cause the Edit Indicator to appear. 42 MX49/MX61 Owner's Manual