Yamaha RX 497 Owners Manual - Page 45

REMOTE CONTROL FEATURES Setting remote control codes You can control other components by setting the appropriate remote control codes. Codes can be set up for each input source. For a complete list of available remote control codes, refer to "LIST OF REMOTE CONTROL CODES" at the end of this manual. The following table show the default component category (Library) and the remote control code for each input source. Remote control code default settings Input source CD MD/TAPE DVD DTV/CBL* VCR PHONO Default component category (Library) Manufacturer Default YAMAHA code CD YAMAHA 199 TAPE YAMAHA 499 DVD YAMAHA 699 - - - - - - - - - * You can only set the TV remote control codes for the DTV/ CBL button. However, other remote control codes can be set for any input selector buttons except DTV/CBL. Note You may not be able to operate your other YAMAHA components even if the YAMAHA remote control code is initially set as listed above. In this case, try setting other YAMAHA remote control codes. 1 Press and hold CODE SET on the remote control and then press one of the input selector buttons on the remote control to select the input source you want to set up. CODE SET MENU POWER POWER TV AV STANDBY POWER CD MD/TAPE TUNER XM DVD DTV/CBL VCR PHONO Note You must press and hold CODE SET throughout this operation. 2 While holding down CODE SET on the remote control, use the numeric buttons on the remote control to enter the three-digit remote control code for the selected input source. When the setting succeeds, "PRESET OK" appears; however, when it does not, "PRESET NG" appears in the front panel display. To reset the code, enter the default code for each input source listed in the remote control code default settings table. CODE SET MENU 1 2 3 4 5 6 7 8 9 0 10 ENT. TITLE BAND ENTER A-E/CAT. RETURN MEMORY PRESET/CH MENU SRCH MODE A-E/CAT. DISPLAY Notes • If the manufacturer of your component has more than one code, try setting each of them until you find the correct one. • You can only assign one remote control code to each input selector button. ADVANCED OPERATION 41