Yamaha RX-V1400 Owner's Manual - Page 29
Starting the setup, When WIRING, DISTANCE, SIZE or LEVEL is - thx receiver
View all Yamaha RX-V1400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
PREPARATION AUTO SETUP Starting the setup For best results, make sure the room is as quiet as possible during the auto setup procedure. If there is too much ambient noise, the results may not be satisfactory. y If your subwoofer can adjust the output volume and the crossover frequency, set the volume to about half way (or slightly less) and set the crossover frequency to the maximum. 1 Switch on the receiver and video monitor. Make sure the OSD is displayed. 2 Press AMP to select the AMP mode, then press SET MENU to enter the SET MENU. AMP then SET MENU MENU A/B/C/D/E 3 Press u / d to select AUTO SETUP, then press i once to enter the main menu. + TV VOL CH - PRESET TV MUTE SELECT TV VOL - CH + PRESET SET MENU . ;AUTO SETUP ;MANUAL SETUP / : Up/Down SELECT : Select p p + TV VOL CH - PRESET TV MUTE SELECT TV VOL - CH + PRESET 4 Press u / d repeatedly to select WIRING, DISTANCE, SIZE, EQUALIZING or LEVEL. 1 AUTO SETUP . WIRING;;;;;CHECK DISTANCE;;;CHECK SIZE;;;;;;;CHECK SWFR;;;;;;;SKIP SETUP......AUTO START PUSH SELECT / : Up/Down -/+ : Change p p 5 When WIRING, DISTANCE, SIZE or LEVEL is selected, press j / i to select: CHECK SKIP To automatically check and adjust the selected item. To skip the selected item and perform no adjustments. y When using THX speakers, set SIZE to SKIP and make sure that SMALL or SMLx2 is selected in SPEAKER SET (page 49) and that 80Hz is selected in CROSS OVER (page 50). When EQUALIZING is selected, press j / i to select: FRONT To adjust the frequency response of each speaker in accordance with the sound of your front speakers. Recommended if your front speakers are of much higher quality than your other speakers. FLAT To average the frequency response of all speakers. Recommended if all of your speakers are of similar quality. LOW To average the frequency response of all speakers, giving priority to the accuracy of bass frequencies. MID To average the frequency response of all speakers, giving priority to the accuracy of mid-range frequencies. HIGH To average the frequency response of all speakers, giving priority to the accuracy of high frequencies. SKIP To skip the selected item and perform no adjustments. 6 Press d to select SETUP, then press j / i to select: AUTO To automatically perform the entire auto setup procedure. STEP To pause for confirmation between each check in the auto setup procedure. RELOAD To restore the last auto setup setting. 7 Press d to select START PUSH +, then press i. Loud test tones will be output from each speaker and WAIT appears during the auto setup procedure. Note If E-10:OTHER ERROR appears during testing, restart the procedure from step 3. English 25