Yamaha RX-V1400 Owner's Manual - Page 81
TROUBLESHOOTING, General
View all Yamaha RX-V1400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 81 highlights
TROUBLESHOOTING TROUBLESHOOTING Refer to the chart below when this unit does not function properly. If the problem you are experiencing is not listed below or if the instruction below does not help, set this unit to the standby mode, disconnect the power cord, and contact the nearest authorized YAMAHA dealer or service center. ■ General Problem This unit fails to turn on when STANDBY/ ON (or SYSTEM POWER) is pressed, or enters in the standby mode soon after the power has been turned on. On screen display does not appear. No sound No picture Cause Remedy Refer to page The power cord is not connected or the Connect the power cord firmly. - plug is not completely inserted. The impedance setting is incorrect. Set the impedance to match your speakers. 23 The protection circuitry has been activated. Make sure all speaker wire connections on this unit and on all speakers are secure and that the wire for each connection does not touch anything other than its respective connection. 12-14 This unit has been exposed to a strong Set this unit in the standby mode, disconnect the - external electric shock (such as lightning power cord, plug it back in after 30 seconds, then use and strong static electricity). it normally. The setting for the on-screen display is set Select the full or short display mode. 44 to "DISPLAY OFF". GRAY BACK in the SET MENU is set to Set GRAY BACK to AUTO to always show the OSD. 56 OFF, and no video signal is currently being received. Incorrect input or output cable connections. Connect the cables properly. If the problem persists, the cables may be defective. 16-19 INPUT MODE is set to DTS or Select AUTO. 34 ANALOG. No appropriate input source has been Select an appropriate input source with INPUT, 30 selected. MULTI CH INPUT or the input selector buttons. Speaker connections are not secure. Secure the connections. 12 The front speakers to be used have not Select the front speakers with SPEAKERS A and/or 30 been selected properly. B. The volume is turned down. Turn up the volume. - The sound is muted. Press MUTE or any operation buttons of this unit to 31 cancel a mute and adjust the volume. If you are playing an LD source, the Set the INPUT MODE to ANALOG. 34 player may not output digital signals if the LD source was not digitally recorded. The INPUT MODE is set to ANALOG Set the INPUT MODE to AUTO or DTS. 34 while playing a source encoded with a DTS signal. The signals this unit cannot reproduce are Play a source whose signals this unit can reproduce. - being received from a source component e.g.: a CD-ROM. The output and input for the picture are Turn on the video conversion function. 56 connected to different types of video jacks. ADDITIONAL INFORMATION English 77