Yamaha RX-V485 RX-V485/RX-D485 Owner s Manual - Page 19
Connecting the subwoofer, n
View all Yamaha RX-V485 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
NOTE ▪ Remove the unit's power cable from an AC wall outlet before connecting the speakers. ▪ Be sure to connect the front left and right speakers. ▪ (U.S.A. and Canada models only) Under its default settings, the unit is configured for 8-ohm speakers. When connecting 6-ohm speakers, set the unit's speaker impedance to "6 Ω MIN". For details, see the following: - "Setting the speaker impedance" (p.18) 1 Remove approximately 10 mm (3/8") of insulation from the ends of the speaker cable, and twist the bare wires of the cable firmly together. 2 Loosen the speaker terminal. 3 Insert the bare wires of the cable into the gap on the side (upper right or bottom left) of the terminal. 4 Tighten the terminal. + (red) c b FRONT - (black) da This completes the connection. NOTE ▪ If "Check SP Wires" appears on the front display when the unit is turned on, turn off the unit, and then confirm that the speaker cables are not short circuited. ▪ (U.S.A., Canada, China, Taiwan, Brazil, Central and South America and General models only) When using a banana plug, tighten the speaker terminal and insert a banana plug into the end of the terminal. Banana plug a FRONT b n Connecting the subwoofer Use an audio pin cable to connect the subwoofer. NOTE Unplug the power cables of the unit and subwoofer from the AC wall outlets before connecting the subwoofer. Audio pin cable AUDIO 3 19 En