Yamaha RX-Z11 Owner's Manual - Page 76
Setting the XM™ Satellite Radio preset channels, Direct Number Access mode
UPC - 027108929019
View all Yamaha RX-Z11 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 76 highlights
XM™ Satellite Radio tuning (U.S.A. and Canada models only) ■ Direct Number Access mode 1 Press ISRCH MODE on the remote control repeatedly to select "ALL CH SEARCH" or "CAT SEARCH". ALL CH SEARCH or CAT SEARCH 2 Press the numeric buttons (B) on the remote control to enter the desired three-digit channel number. For example, to enter the number 123, press the numeric buttons as shown below. CLASSICAL 1 1 CLASSICAL 2 2 LIVE/CLUB 3 Before performing the following operations, set the operation mode selector on the remote control to FSOURCE and then press 3XM. Setting the XM™ Satellite Radio preset channels You can use this feature to store up to 40 XM Satellite Radio channels (A1 to E8: 8 preset channel numbers in each of the 5 preset channel groups). You can then recall any preset channel easily by selecting the preset channel group and number as described in "Preset Search mode" on page 75. 1 Search for a channel you want to set as a preset channel by using one of the XM Satellite Radio search modes. [043] XMU Currently selected channel number The display changes as follows. --1 2 Press JMEMORY (or 0MEMORY). The MEMORY indicator flashes in the front panel display for approximately 10 seconds. MEMORY -12 123 y • To enter a one-digit or two-digit channel number, press the numeric buttons (B) on the remote control and then press NENT to confirm the input number. • If no button is pressed within a few seconds after you enter a one-digit or two-digit number, this unit automatically confirms the entered channel number. • If you enter the number 0, this unit displays your XM Radio ID (see page 74). Flashes Note You must proceed to and carry out steps 3 through 5 while the MEMORY indicator is flashing in the front panel display. 3 Press MPROGRAM (or 9CAT. l / h) repeatedly to select a preset channel group (A to E) while the MEMORY indicator is flashing. The preset channel group letter appears in the front panel display. C [043] XMU MEMORY Currently selected preset channel group Flashes 4 Rotate MPROGRAM (or 9PRESET/CH k / n) repeatedly to select a preset channel number (1 to 8) while the MEMORY indicator is flashing. The preset channel number appears in the front panel display. C5 [043] XMU MEMORY Currently selected preset channel number Flashes 76 En