Yamaha VS-10 Owner's Manual - Page 11

INSTALLATION, Installing the Control Center Horizontally

Get Yamaha VS-10 PDF manuals and user guides View all Yamaha VS-10 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 11 highlights

PREPARATION INSTALLATION Depending on room conditions, the control center can be installed vertically or horizontally. Precautions before installation • Do not touch the adhesive surface after peeling off the pad as this will weaken its adhesive strength. • Thoroughly wipe clean the surface where the pad is to be applied. Note that adhesive strength is weakened if the surface is dusty, oily or wet. Installing the Control Center Horizontally Apply the four supplied bottom pads to the bottom of the control center. Peel off the seals of the bottom pads and apply to the four indented parts (screwed parts) on the bottom of the control center. Apply to the indented part. Bottom panel Peel off the seal. Bottom pad CAUTIONS • Be sure to use the bottom pads when installing the control center horizontally. Otherwise, the front door of the control center cannot open. • Be sure to apply the bottom pads to the indented parts (screwed parts) on the bottom panel. Do not apply them to the indented parts on the top of the control center. English 7

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
7
English
PREPARATION
INSTALLATION
Depending on room conditions, the control center can be installed vertically or horizontally.
Precautions before installation
•
Do not touch the adhesive surface after peeling off the pad as this will weaken its adhesive strength.
•
Thoroughly wipe clean the surface where the pad is to be applied. Note that adhesive strength is weakened if the surface is
dusty, oily or wet.
Installing the Control Center Horizontally
Apply the four supplied bottom pads to the bottom of the control center.
Peel off the seals of the bottom pads and apply to the four indented parts (screwed parts) on the bottom
of the control center.
CAUTIONS
•
Be sure to use the bottom pads when installing the control center horizontally. Otherwise, the front door of the control
center cannot open.
•
Be sure to apply the bottom pads to the indented parts (screwed parts) on the bottom panel. Do not apply them to the
indented parts on the top of the control center.
Bottom panel
Bottom pad
Peel off the seal.
Apply to the indented part.