Yamaha VS-10 Owner's Manual - Page 12

Installing the Control Center Vertically

Get Yamaha VS-10 PDF manuals and user guides View all Yamaha VS-10 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 12 highlights

INSTALLATION Installing the Control Center Vertically Apply the two supplied side pads to the side of the control center and attach to the supplied supporting stand. 1 Peel off the seals of the side pads and apply to the two indented parts (near to the front panel) on the left side of the control center. Peel off the seal. Side pad Apply to the indented part. Front panel 2 Attach the control center with the pads applied side facing down to the supporting stand as shown in the illustration below. Front panel Bottom panel Apply to the indented part. Rear panel Lift in this direction. A supporting stand Note • Using only the supporting stand makes the control center unstable and the front door cannot open. Be sure to use the side pads as well. CAUTIONS • Be sure to place the control center with the left side down. • When installing the control center vertically on a high place such as on a shelf, do not place close to the edge. 8

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
8
Note
•
Using only the supporting stand makes the control center unstable and the front door cannot open. Be sure to use the side pads as well.
CAUTIONS
•
Be sure to place the control center with the left side down.
•
When installing the control center vertically on a high place such as on a shelf, do not place close to the edge.
Installing the Control Center Vertically
Apply the two supplied side pads to the side of the control center and attach to the supplied supporting stand.
1
Peel off the seals of the side pads and apply to the two indented parts (near to the front panel) on the
left side of the control center.
2
Attach the control center with the pads applied side facing down to the supporting stand as shown in
the illustration below.
A supporting stand
Lift in this direction.
Front panel
Apply to the indented part.
Bottom panel
Rear panel
Apply to the indented part.
Side pad
Peel off the seal.
Front panel
INSTALLATION