Zanussi ZKN7147J Product Manaul - Page 17

Opening the door after the programme has started First set the machine to pause by pressing the button 7. If the pilot light 9 blinks and after a few minutes goes off, the door can be opened. If the pilot light 9 remains lit, this means that the machine is already heating or that the water level is too high. In any case, do not try to force the door open! If you cannot open the door but you need to open it, you have to switch the machine off by turning the selector dial to . After a few minutes the door can be opened. (Pay attention to the water level and temperature!). After closing the door, it is necessary to select the programme and options again and to press button 7. At the end of the programme The machine stops automatically. The blinking appears on the display, the pilot light of but- ton 7 and the pilot light 9 go off. If a programme or an option that ends with water left in the tub has been selected, the pilot light 9 remains on and the door is locked to indicate that the water must be emptied out before opening the door. Before you empty out the water, the drum continues to run at regular intervals until the water draining. Follow the below instructions to empty out the water: 1. Turn the programme selector dial to . 2. Select the draining or spinning programme. 3. Reduce the spin speed if needed, by pressing the relevant button. 4. Press button 7. At the end of the programme, the door is released and can be opened. Turn the programme selector dial to to switch the machine off. Remove the laundry from the drum and carefully check that the drum is empty. If you do not intend to carry out another wash, close the water tap. Leave the door open to prevent the formation of mildew and unpleasant smells. Stand by : once the programme has finished after a few minutes the energy saving system will be enabled. The brightness of the display is Use - Drying reduced. By pressing any button the appliance will come out of the energy saving status. Drying only Caution! The recommended load size is 4 kg for cottons and linen and 3 kg for synthetic items. By pressing Drying Time button it is also possible to dry up to 6 kg of cotton items (see the «Drying Programme » table). Caution! The water tap must be open and the drain hose must be positioned in the sink or connected to the drain pipe. 1. Load the laundry. 2. Select a spin cycle at the maximum spin speed allowed for the type of laundry in order to obtain the best drying performances. 3. Select the drying programme for Cottons or Synthetic in the Drying sector of the programme selector dial. 4. If you wish to select an automatic drying (for cottons and synthetic items only), press the button 3 until the pilot light corresponding to the required dryness degree illuminates. 5. If you wish to select a timed drying, press the button 4 until the time you want appears on the display (see the «Drying Programme» table). Every time you press this www.zanussi.com 17