Zanussi ZKN7147J Product Manaul - Page 27

If necessary, check the setting with a spirit level. Unscrew the three bolts. Slide out the relevant plastic spacers. Water inlet The inlet hose is supplied with the appliance and it can been found inside the machine drum. Warning! This appliance must be connected to a cold water supply. Open the porthole, remove the polystyrene block fitted on the door seal and pull out all items from the drum. Fill the smaller upper hole and the two large ones with the corresponding plastic plug caps supplied in the bag containing the instruction booklet. Positioning Install the machine on a flat hard floor. Make sure that air circulation around the machine is not impeded by carpets, rugs etc. Check that the machine does not touch the wall or other kitchen units. Level the washing machine by raising or lowering the feet. The feet may be tight to adjust as they incorporate a self locking nut, but the machine MUST be level and stable. Any necessary adjustment can be made with a spanner. Accurate levelling prevents vibration, noise and displacement of the machine during operation. Never place cardboard, wood or similar materials under the machine to compensate for any unevenness in the floor. Caution! Before connecting up the appliance to new pipework or to pipework that has not been used for some time, run off a reasonable amount of water to flush out any debris that may have collected. Caution! Do not use the hose from your previous appliance to connect to water supply. 1. Connect the appropriate end of the hose to a tap with a 3/4" thread. Always use the hose supplied with the appliance. 35° 45° www.zanussi.com 27