Zanussi ZKN7147J Product Manaul - Page 19

2. Switch the machine on by turning the selector dial to the set washing programme/ fabric. 3. Select the required options by pressing the relevant buttons. If possible, do not select a spin speed lower than that proposed by the appliance to avoid too long a drying time therefore saving energy. In any case the reduction of the spin speed is only possible after selecting drying. The lowest values you can select are 900 r.p.m. for cottons and synthetics and 700 r.p.m. for delicate fabrics. Fluff in the fabrics During the WASHING AND/OR DRYING PHASE, certain types of fabric, such as sponge, wool, sweatshirt, could release fluff. The released fluff could stick to the fabrics during the next cycle. This drawback increases with technical fabrics. To prevent the fluff in your clothes, it is recommended: • To do not wash dark fabrics after you washed and dried light colored fabrics (new sponge, wool, sweatshirt especially) and vice versa. • To air-dry this type of fabrics when they are washed the first time. Care and cleaning 4. Set the drying time by pressing button 4. The display shows the whole duration of the washing and the set drying cycle. If you set a washing programme and only 10 minutes of drying cycle, the total duration displayed includes also the unrolling and the cooling phase. 5. Start the programme by pressing button 7. The time remaining is updated every minute on the display. 6. At the end of the programme turn the selector dial to the position to switch the machine off and remove the laundry. • To clean the drain filter. • After the drying phase, thoroughly clean the empty drum, the gasket and the door with a wet rag. To remove the fluff inside the drum, run a special programme to clean it: • Empty the drum and clean the drum, the gasket and the door with a wet rag. • Turn the programme selector to the rinse programme. • Activate the cleaning function by pressing at the same time button 5 and button 8 until the display shows CLE. • Press button 7 to start the programme. Warning! You must DISCONNECT the appliance from the electricity supply, before you can carry out any cleaning or maintenance work. Descaling The water we use normally contains lime. It is a good idea to periodically use a water softening powder in the machine. Do this separately from any laundry washing, and according to the softening powder manufacturer's instructions. This will help to prevent the formation of lime deposits. External cleaning Clean the exterior cabinet of the appliance with soap and water only, and then dry thoroughly. Cleaning the dispenser drawer The washing powder and additive dispenser drawer should be cleaned regularly. www.zanussi.com 19