Zanussi ZOD35702XK Product Manaul - Page 17

3. Close the oven door until the first position (angle approx. 45°). 3. Hold the door glass panels on their top edge one by one and pull them upwards out of the guide 4. Clean the door glass panels. To install panels follow the procedure in reverse. Insert the smaller panel first, then the larger. 45° 4. Hold of the oven door with one hand on each side and pull it away from the oven at an upwards angle. Put the oven door with the outer side down on a soft and level surface to prevent scratches. 5. Now you can remove the inner glass panels and clean them. To install the door follow the procedure in reverse. The oven door has 2, 3 or 4 panels of glass (depends on the model) Removing and cleaning the door glasses 1. Hold the door trim (B) on the top edge of the door at the two sides and push inwards to release the clip seal. Oven lamp Warning! There is a danger of electrical shock! Before you change the oven lamp: • Switch off the oven. • Remove the fuses in the fuse box or switch off the cir- cuit breaker. Put a cloth on the bottom of the oven for protection of the oven light and glass cover. Replacing the oven lamp 1. You can find the lamp glass cover at the back of the cavity. Turn the lamp glass cover counterclockwise to remove it. 2. Clean the glass cover. 3. Replace the oven lamp with applicable 300°C heatresistant oven lamp. Important! Use the same oven lamp type. 4. Install the glass cover. B 2. Pull the door trim to the front to remove it. What to do if... Warning! Refer to "Safety information" chapter. www.zanussi.com 17