ZyXEL PLA4215 User Guide - Page 17

Power, Ethernet, HomePlug, ENCRYPT, Installing the Utility, PLA4215 User's Guide

Get ZyXEL PLA4215 PDF manuals and user guides View all ZyXEL PLA4215 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 17 highlights

Chapter 2 Installing the Utility When you plug the PLA4215 into an electric socket, it waits for an Ethernet connection. When no connection is detected after sixty (60) seconds, the Power LED blinks indicating that it is going into Low Power mode. The same process occurs when you disconnect the PLA4215 from a previously working Ethernet connection. Sixty (60) seconds after disconnecting the Ethernet cable, the PLA4215's Power LED blinks signalling that it is going into Low Power mode. The Ethernet and HomePlug LEDs are turned off in Low Power mode. While in Low Power mode, you cannot use the ENCRYPT button. To enable the ENCRYPT button again, you have to connect the PLA4215's Ethernet cable to a computer/notebook or modem/router first. The PLA4215 wakes up from Low Power mode and you can start using the ENCRYPT button. Low Power mode is enabled by default. PLA4215 User's Guide 17

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
Chapter 2 Installing the Utility
PLA4215 User’s Guide
17
When you plug the PLA4215 into an electric socket, it waits for an Ethernet connection. When no
connection is detected after sixty (60) seconds, the
Power
LED blinks indicating that it is going into
Low Power mode.
The same process occurs when you disconnect the PLA4215 from a previously working Ethernet
connection. Sixty (60) seconds after disconnecting the Ethernet cable, the PLA4215’s
Power
LED
blinks signalling that it is going into Low Power mode.
The
Ethernet
and
HomePlug
LEDs are turned off in Low Power mode.
While in Low Power mode, you cannot use the
ENCRYPT
button. To enable the
ENCRYPT
button
again, you have to connect the PLA4215’s Ethernet cable to a computer/notebook or modem/router
first. The PLA4215 wakes up from Low Power mode and you can start using the
ENCRYPT
button.
Low Power mode is enabled by default.