2010 Chevrolet Equinox Owner's Manual - Page 177
2010 Chevrolet Equinox Manual
Page 177 highlights
Infotainment System Infrared transmitters are on the top of the left seatback video screen. The headphones shut off automatically to save the battery power if the RSE system is shut off or if the headphones are out of range of the transmitters for more than three minutes. Moving too far forward or stepping out of the vehicle, can cause the headphones to lose the signal or have static. The headphones may automatically turn off after four hours of continuous use. To adjust the volume on the headphones, use the volume control. For best audio performance, the headphones must be worn correctly, with the headband over the top of the head. L (Left) and R (Right) are above the ear pads and are indicators as to how the headphones should be placed on the head. Notice: Do not store the headphones in heat or direct sunlight. This could damage the headphones and repairs will not be covered by the warranty. Storage in extreme cold can weaken the batteries. Keep the headphones stored in a cool, dry place. If the foam ear pads become worn or damaged, they can be replaced separately from the headphones. See your dealer/retailer for more information. Battery Replacement To change the batteries: 1. Loosen the screw to the battery door located on the left side of the headphones. 2. Slide the battery door open. 3. Replace the two AAA batteries. 4. Replace the battery door and tighten the screw. 6-35 Remove the batteries if the headphones are not going to be used for a long period of time. Audio/Video (A/V) Jacks If available, the A/V jacks are located on the rear of the floor console. They allow audio or video cables to be connected from an auxiliary device such as a camcorder or a video game system. The A/V jacks are color coded: ... Yellow for video input. White for left audio input. Red for right audio input. Power for auxiliary devices is not supplied by the radio system. To use the auxiliary inputs of the RSE system: 1. Connect the auxiliary device cables to the A/V jacks. 2. Power on both the auxiliary device and the RSE video screen.